Dimplex DCAC20T Buku Petunjuk - Halaman 11

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Kipas angin Dimplex DCAC20T. Dimplex DCAC20T 16 halaman. Dc air circulator

Operation

WIND MODE

By default, when the wind mode button is first pressed, the device will automatically

be on normal wind mode. Press the button again to switch modes. This will switch

the device wind modes in the following sequence: Normal - Natural - Sleep - Normal

etc. The corresponding indicator shows the function. The normal wind speed mode

has no indicator. When you switch the wind mode to natural, the LED display will

show a leaf. In natural wind mode, the 32 speeds are divided into three groups. 1-10

is low level natural wind speed, 11-20 is medium level and 21-32 is high level. The

display shows 10 levels under low level, 20 under medium and all 32 under high level.

In natural mode, the encoder switch can only select level 10, level 20 or level 32 wind

speed. When you switch the device to sleep mode, the LED display shows a moon.

In sleep mode, the encoder switch can only select level 10, level 20 or level 32.

VERTICAL SWING

Press the Up/Down Swing button to set off the vertical swing functionality. This

device will oscillate up to 80° vertically. When this function is switched on, the LED

display will show the vertical arrow symbol.

HORIZONTAL SWING

Press the Left/Right swing button to set of the horizontal swing functionality. This

device can oscillate up to 360° horizontally. You can select how much swing you

desire by pressing the button multiple times. You can choose between 30°, 90°, 180°

or the full 360°. 30° is the default setting. The LED display will show the desired

angle setting, as well as the side to side arrow icon.

SCREEN OFF

Press the Screen Off button to turn the display off whilst in operation. This will

ensure all indicator lights are switched off.

OTHER

Power Memory Function: By pressing the On/Off button in standby state, your

device will remember the state it was operating in before it was shut off, and

automatically return to these settings. Please note however, the timer function will

always need to be reset.

Display Brightness: After the device has been working for 1 minute, continuously,

the brightness of the display will be reduced to 1/3 of the normal brightness level to

reduce glare at night.