Aeon Labs Minimote Manual - Halaman 3

Jelajahi secara online atau unduh pdf Manual untuk Kontrol Jarak Jauh Aeon Labs Minimote. Aeon Labs Minimote 7 halaman. Z-wave remote controller
Juga untuk Aeon Labs Minimote: Manual (7 halaman)

Halaman Cetak

Scene 1 (max. nodes in group: 5)

Scene 2 (max. nodes in group: 5)

Scene 3 (max. nodes in group: 5)

Scene 4 (max. nodes in group: 5)

Set and unset associations to actuators

Associations can be assigned and remove either via Z-Wave commands or using the device itself.

Press the scene button the new device shall be associated with and keep this button pressed.

Issue a Node Information Frame from the target device. This is usually done by single or triple click a button. Please refer to the

manual of this device how to issue a NIF.

Before releasing the scene button turn the device into the desired state. After the button is released the minimote will detect

the status of the device and store it in the scene.

To delete a device from a scene repeat the process for the scene where the device was already associated with.

Special Functions as Z-Wave Controller

As long as this device is not included into a Z-Wave network of a different controller it is able to manage its own Z-Wave network

as primary controller. As a primary controller the device can include and exclude other devices in its own network, manage

associations, and reorganize the network in case of problems. The following controller functions are supported:

Include other device in own network

Communication between two Z-Wave devices only works if both belong to the same wireless network. Joining a network is

called inclusion and is initiated by a controller. The controller needs to be turned into the inclusion mode. Once in this inclusion

mode the other device needs to confirm the inclusion - typically by pressing a button.

Click the "Inclusion" button to start the inclusion mode.

If inclusion of a new device fails, first exclude it from its previous network or reset it.

If current primary controller in your network is in special SIS mode this and any other secondary controller can also include and

exclude devices.

To become primary a contoller have to be resetted and then include a device.

Exclude device from network

The primary controller can exclude devices from the Z-Wave network. During exclusion the relationship between the device and

the network of this controller is terminated. No communication between the device and other devices still in the network can

happen after a successful exclusion. The controller needs to be turned into the exclusion mode. Once in this exclusion mode the

other device needs to confirm the exclusion - typically by pressing a button.

Attention: Removing a device from the network means that it is turned back into factory default status. This process can also

exclude devices from it's previous network.

Click the "Exclusion" button to start the exclusion mode.

Attention: Removing a device from the network means that it is turned back into factory default status. This process can also

exclude devices from its previous network.