Pioneer AVIC-F970BT Panduan Instalasi - Halaman 22

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Penerima Mobil Pioneer AVIC-F970BT. Pioneer AVIC-F970BT 32 halaman. In-dash navigation av receivers and dvd receivers
Juga untuk Pioneer AVIC-F970BT: Panduan Memulai Cepat (2 halaman), Petunjuk Pembaruan Firmware Sistem (5 halaman)

Halaman Cetak

Section

Installation

For AVIC-F70BT users

Do not install this product in a position where

the opening of the LCD panel is obstructed by

any obstacles, such as the gearstick. Before

installing this product, be sure to leave suffi-

cient space so that the LCD panel does not ob-

struct the gearstick when it is fully opened.

This may cause interference with the gear-

stick, or a malfunction of the mechanism of

this product.

Installing this product

Installation notes

! Do not install this product in places subject

to high temperatures or humidity, such as:

— Places close to a heater, vent or air con-

ditioner.

— Places exposed to direct sunlight, such

as on top of the dashboard.

— Places that may be exposed to rain,

such as close to the door or on the vehi-

cle's floor.

! Install this product in an area strong en-

ough to bear its weight. Choose a position

where this product can be firmly installed,

and install it securely. If this product is not

securely installed, the current location of

the vehicle cannot be displayed correctly.

! Install this product horizontally on a sur-

face within 0 to 30 degrees tolerance (with-

in 5 degrees to the left or right). Improper

installation of the unit with the surface

tilted more than these tolerances increases

the potential for errors in the vehicle's loca-

tion display, and might otherwise cause re-

duced display performance.

30°

Engb

5°

! When installing, to ensure proper heat dis-

persal when using this unit, make sure you

leave ample space behind the rear panel

and wrap any loose cables so they are not

blocking the vents.

Leave ample

5 cm

space

5 cm

! The cords must not cover the area shown

in the figure below. This is necessary to

allow the amps and navigation mechanism

to dissipate heat.

Do not cover this area.

! The semiconductor laser will be damaged

if it overheats, so don't install this product

anywhere hot — for instance, near a heater

outlet.

5°