Din Sync VCF303 Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Musik Din Sync VCF303. Din Sync VCF303 14 halaman. Eurorack filter module

Filter Section

The CUT OFF FREQ knob adjusts the cutoff point of

the filter. Turning the knob to the right allows more high

frequency content to pass, resulting in brighter timbres.

Turning the knob to the left closes the filter and less high

frequency content is passed, resulting in duller timbres.

As on the original TB-303 it is not possible to close the

filter completely from the knob alone.

The CV input jack allows voltage control of the cutoff

frequency. Use this jack with LFO's or audio rate

modulations. If you use an offset generator with this input

you will be able to take the cutoff frequency beyond that

of the TB-303. This will enable you to close the filter

completely, or open it more than the standard range.

This jack is not attenuated, so in some cases, ie with an

LFO it may be necessary to attenuate the signal before it

reaches this input jack.

When the RESONANCE knob is turned up harmonics at

the cutoff frequency are boosted.

As more resonance is added the overall timbre becomes

thinner and more "acidic".

With little or no resonance the overall timbre becomes

thicker and more chunky. Try some no resonance

basslines with an OSC303 for some lush bouncy tones.