Pioneer DEH-4090MP Panduan Pemilik - Halaman 19

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penerima Mobil Pioneer DEH-4090MP. Pioneer DEH-4090MP 34 halaman.

Halaman Cetak

Initial Settings

Adjusting initial settings

Press SRC and hold until the unit turns

off.

Press MULTI-CONTROL and hold until

CLOCK SET appears in the display.

Turn MULTI-CONTROL to select one of

the initial settings.

CLOCK SET (clock)—FM STEP (FM tuning

step)—AM STEP (AM tuning step)—

WARNING TONE (warning tone)—AUX (aux-

iliary input)—DIMMER (dimmer)—

SW CONTROL (rear output and subwoofer

controller)—DEMO MODE (feature demo)—

EVER SCROLL (ever scroll)

# You can also perform the same operations by

pushing MULTI-CONTROL up or down.

# You can also select the function by pressing

FUNCTION on the remote control.

# To cancel initial settings, press BAND/ESC.

Setting the clock

Use these instructions to set the clock.

Use MULTI-CONTROL to select

CLOCK SET.

Press MULTI-CONTROL to display the

setting mode.

# Press BACK to return to the previous display.

Press MULTI-CONTROL to select the seg-

ment of the clock display you wish to set.

Each time you press MULTI-CONTROL, one

segment of the clock display is selected.

Hour—Minute

As you select segments of the clock display,

the selected segment blinks.

Turn MULTI-CONTROL to put a clock

right.

# You can also perform the same operations by

pushing MULTI-CONTROL up or down.

Setting the FM tuning step

The FM tuning step employed by seek tuning

can be switched between 100 kHz, the preset

step, and 50 kHz.

! If seek tuning is performed in 50 kHz steps,

stations may be tuned in imprecisely. Tune

in the stations with manual tuning or use

seek tuning again.

Use MULTI-CONTROL to select FM STEP.

Press MULTI-CONTROL to display the

setting mode.

Turn MULTI-CONTROL to select the FM

tuning step.

Turning MULTI-CONTROL will switch the FM

tuning step between 50 kHz and 100 kHz. The

selected FM tuning step will appear in the dis-

play.

# You can also perform the same operations by

pushing MULTI-CONTROL up or down.

Note

The tuning step remains at 50 kHz during manual

tuning.

Setting the AM tuning step

The AM tuning step can be switched between

9 kHz, the preset step, and 10 kHz. When

using the tuner in North, Central or South

America, reset the tuning step from 9 kHz (531

kHz to 1 602 kHz allowable) to 10 kHz (530 kHz

to 1 640 kHz allowable).

Use MULTI-CONTROL to select

AM STEP.

Press MULTI-CONTROL to display the

setting mode.

Section