Pioneer MVH-X580BT Panduan Pemilik - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penerima Mobil Pioneer MVH-X580BT. Pioneer MVH-X580BT 28 halaman.

Halaman Cetak

Turn the M.C. dial to select [PHONE CONNECT], then press to confirm.

Turn the M.C. dial to select one of the below, then press to confirm.

• Select [IPHONE/IPOD] for iPhone.

• Select [ANDROID] for Android device.

Turn the M.C. dial to select one of the below.

• Select [WIRED] for the USB connection.

• Select [BLUETOOTH] for the Bluetooth connection.

Proceed to step 10 if you select the USB connection for iPhone or the Bluetooth

connection.

NOTE

When the connection setting is changed, a message that lets you know that the connection

setting had been changed will appear in the display. Press the M.C. dial and turn the M.C. dial to

select [SRC OFF :YES], then press to confirm. The unit turns off automatically and the setting is

executed.

Repeat steps 2 to 3.

Turn the M.C. dial to select [ANDROID WIRED], then press to confirm.

Turn the M.C. dial to select [APP CONTROL] for an Android device connected via

USB.

If [ON] is selected in [P.APP AUTO ON] (page 18), Pioneer ARC APP on the Android

device starts automatically, and all the steps are finished.

NOTE

If Pioneer ARC APP has not been installed on your Android device yet, a message that prompts you

to install the application will appear on your Android device. Select [OFF] in [P.APP AUTO ON] to

clear the message (page 18).

Press SRC/OFF to select any source.

Launch Pioneer ARC APP on the mobile device.

NOTE

You can also launch the application by pressing and holding the M.C. dial if you select the USB

connection for iPhone or the Bluetooth connection.

Listening to music on Android

Press SRC/OFF to select [ANDROID].

Basic operations

Purpose

Select a track

Fast forward or reverse

Pause/resume playback

Audio adjustments

You can also make various adjustments in the AUDIO settings (page 16).

Operation modes

This unit features two operation modes: network mode and standard mode. You can

switch between modes as desired (page 5).

Network mode

You can create a 2-way + SW multi-amp and multi-speaker system with high range

speaker, middle range speaker and subwoofer for reproduction of high, middle and low

frequencies (bands).

Standard mode

You can create a 4-speaker system with front and rear speakers or front speakers and

subwoofers, or a 6-speaker system with front and rear speakers and subwoofers.

Adjusting the cut-off frequency value and the slope

value

You can adjust the cut-off frequency value and the slope value of each speaker.

The following speakers can be adjusted.

Network mode:

[HIGH] (high-range speaker HPF), [MID HPF] (middle-range speaker HPF), [MID LPF]

(middle-range speaker LPF), [SUBWOOFER]

Standard mode:

[FRONT], [REAR], [SUBWOOFER]

NOTE

[SUBWOOFER] can only be selected when [ON] is selected in [SUBWOOFER] (page 16).

Press the M.C. dial to display the main menu.

Autogoods "130"

Operation

Press

Press and hold

Press 4/PAUSE.