Pioneer AVH-190DVD Panduan Instalasi - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Penerima Pioneer AVH-190DVD. Pioneer AVH-190DVD 45 halaman. Dvd rds av receiver
Juga untuk Pioneer AVH-190DVD: Panduan Pemilik (49 halaman), Panduan Memulai Cepat (33 halaman), Panduan Pengoperasian (38 halaman), Panduan Pemilik (45 halaman)

Halaman Cetak

Installation

1 2

1 Trim ring

2 Groove

Attach the trim ring with the side with a groove facing

downward.

Installation using the screw

holes on the side of this

product

1 Fastening this product to the factory

radio-mounting bracket.

Position this product so that its screw holes are aligned with

the screw holes of the bracket, and tighten the screws at three

locations on each side.

Use either the truss head screws (5 mm × 9 mm) or flush

surface screws (5 mm × 9 mm), depending on the shape of the

bracket's screw holes.

1 Factory radio-mounting bracket

2 If the pawl interferes with installation, you may bend it down

out of the way.

3 Dashboard or console

4 Truss head screw or flush surface screw

Be sure to use the screws supplied with this product.

Installing the microphone

290BT



Install the microphone in a place where its direction and dis-

tance from the driver make it easiest to pick up the driver's

voice.



Be sure to turn off (ACC OFF) the product before connecting

the microphone.



Depending on the vehicle model, the microphone cable

length may be too short when you mount the microphone on

the sun visor. In such cases, install the microphone on the

steering column.

Mounting on the sun visor

1 Fit the microphone lead into the groove.

1 Microphone lead

2 Groove

2 Attach the microphone clip to the sun visor.

1 Microphone clip

2 Clamps

Use separately sold clamps to secure the lead where neces-

sary inside the vehicle.

Install the microphone on the sun visor when it is in the up

position. It cannot recognise the driver's voice if the sun visor is

in the down position.

Installation on the steering

column

1 Detach the microphone base from the micro-

phone clip by sliding the microphone base

while pressing the tab.

1 Tab

2 Microphone base

2 Mount the microphone on the steering column.