Pioneer AVIC-F80DAB Panduan Instalasi - Halaman 25

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Penerima Pioneer AVIC-F80DAB. Pioneer AVIC-F80DAB 32 halaman. Navigation av system
Juga untuk Pioneer AVIC-F80DAB: Panduan Memulai Cepat (16 halaman), Petunjuk Pembaruan Firmware Sistem (5 halaman)

Halaman Cetak

Installation

! The cords must not cover the area shown

in the figure below. This is necessary to

allow the amps and navigation mechanism

to dissipate heat.

Do not cover this area.

! The semiconductor laser will be damaged

if it overheats, so don't install this product

anywhere hot — for instance, near a heater

outlet.

Parts supplied

This product

Flush surface screw

(5 mm × 9 mm)

(6 pcs.)

Installation using the screw

holes on the side of this product

% Fastening this product to the factory

radio-mounting bracket.

Position this product so that its screw holes

are aligned with the screw holes of the brack-

Truss head screw

(5 mm × 8 mm)

(6 pcs.)

et, and tighten the screws at three locations

on each side.

Use either the truss head screws (5 mm ×

8 mm) or flush surface screws (5 mm ×

9 mm), depending on the shape of the brack-

et's screw holes.

If the pawl interferes with installation,

you may bend it down out of the way.

1 Factory radio-mounting bracket

2 Dashboard or console

3 Truss head screw or flush surface screw

Be sure to use the screws supplied with

this product.

Engb

Section