Pioneer F-208 Panduan Petunjuk Pengoperasian - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Penerima Pioneer F-208. Pioneer F-208 34 halaman. Fm/am digital-synthesizer tuner
Juga untuk Pioneer F-208: Katalog (10 halaman), Panduan Servis (21 halaman)
Halaman Cetak
BASIC TUNING OPERATIONS
The following steps show you how to tune in FM and
AM radio broadcasts using "Auto and Manual Tuning". If
you already know the exact frequency of the station you
want, see "Direct Access Tuning" on the following page.
AUTO AND MANUAL TUNING
MPX MODE
1
RF ATT
2
1
. Turn the
STANDBY/ON switch ON.
2
. Press the desired BAND button.
3
. Tuning into the frequency of a desired
station.
Press the TUNING MODE button to select the tun-
ing mode.
Each time you press this button, the tuning mode
changes as follows.
Manual tuning mode
Preset station tuning mode
Tune into desired frequency with the TUNING knob.
¶ During auto tuning, the AUTO indicator in the
display lights. No indicator lights during manual
tuning. During preset station tuning, the station
number or station name is displayed.
4
. To receive another station in the same
band, repeat step
in the other band, repeat steps
5
. Adjust the volume and tone of the
stereo amplifier.
10
En
3
3
Auto tuning mode
3
. To receive a station
2
and
[Manual tuning mode]
To raise the frequency, turn clockwise; to lower the fre-
quency, turn counterclockwise.
[Auto tuning mode]
To tune into a frequency higher than the one indicated,
turn the TUNING knob clockwise. To tune into a frequency
lower than the one indicated, turn the TUNING knob coun-
terclockwise; release when the frequency indication starts
changing. The frequency display changes, and tuning
automatically stops when a frequency that can be received
is found.To search for another station, turn the TUNING
knob once more.
NOTES:
(On auto tuning)
¶ Because of the high sensitivity of this unit, it may auto-
matically stop even at very weak overseas stations.
The same can happen with aggregate radio noise emit-
ted in cities.
¶ During reception of an AM broadcast, auto tuning of
only strong local stations is possible by changing the
direction of the loop antenna or folding it down. After
tuning, move the loop antenna back to its previous
position.
¶ Tune extremely weak stations with manual tuning.
¶ If the radio waves of available stereo stations are
weaker than a certain level,the auto-tuning may not
function for these stations.
(When receiving FM broadcasts)
¶ If there is distortion because the radio signal is too
strong, press the RF attenuator (RF ATT) button to light
the RF ATT indicator.
¶ If there is too much noise during reception of an FM
stereo broadcast, press the MPX MODE button to light
the MONO indicator. Switching to monaural reception
results in clearer reception.
The TUNED indicator
When the TUNED indicator is not lit, reception is not pos-
sible even if the tuning frequency is correct. This is be-
cause the antenna terminal input is too weak. Check
whether the antenna cable is firmly connected. If it is,
consult your nearest dealer and install an outdoor antenna.
Last station memory
3
.
¶ When the
the power on, the last station received before the power
was turned off will be received again.
¶ When the power is ON and the BAND button is
pressed, the last station received on that band will be
received again.
STANDBY/ON switch is pressed to turn