Pioneer XV-DV353 Panduan Petunjuk Pengoperasian - Halaman 45
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Penerima Pioneer XV-DV353. Pioneer XV-DV353 50 halaman. Dvd/cd receiver; speaker system
Juga untuk Pioneer XV-DV353: Panduan Petunjuk Pengoperasian (48 halaman)
Halaman Cetak
Additional information
HDMI connection
Problem
No HDMI audio output.
No HDMI video output
Color problems occur
with your monitor after
changing the HDMI
Color setting (page 28).
Error Messages
Message
2CH ONLY
96K
SND. DEMO
NOISY
ERR MIC
ERR SP
MUTING
STEREO
TRAYLOCK
KEY LOCK
PHONESIN
USB ERR
(XV-DV656 only)
Remedy
• See Switching the HDMI audio setting on page 34 to make sure that AUDIO ON
is selected.
• Make sure that you've selected this player as the HDMI input in the settings for
the component you're using (refer to the component's instruction manual).
• Check that the HDMI cable is connected properly and isn't damaged.
• Check that components connected using the HDMI interface are switched on
and HDMI compatible. (components must be compatible with both DVI and High
Bandwidth Digital Content Protection (HDCP).)
• This unit has been designed to be compliant with HDMI Version 1.1. Depending
on the component you have connected, using a DVI connection may result in
unreliable signal transfers.
• Make sure the resolution on this unit matches that of the component connected
using HDMI. See Video Output settings on page 27 to change the resolution.
• If the screen goes blank after changing the resolution, it means the you selected
a resolution incompatible with your monitor. See Resetting the HDMI connection
on page 34 to reset to the factory defaults.
• Depending on the connected equipment, some HDMI Color settings may cause
the picture to be displayed incorrectly. In this case, use the TV's own video input
settings to select RGB, if possible. Alternatively, revert to the previous HDMI Color
setting.
Description
• An operation is prohibited because it is only applicable to 2 channel sources,
while the current source is a multichannel source.
• An operation is prohibited because the source is 96 kHz digital.
• The sound demo is on. See General in Troubleshooting on page 42.
• Background noise is too high to complete MCACC setup successfully.
• An error occured during MCACC setup because the microphone is not
connected or is not connected properly.
• An error occured during MCACC setup because the speakers are not connected
or are not connected properly.
• An operation is prohibited because the sound is muted (press MUTE).
• An operation is prohibited because the tuner is selected.
• The tray lock is on. See General in Troubleshooting on page 42.
• The key lock is enabled. See Key lock setting on page 37.
• An operation is prohibited because the headphones are connected.
• See Important in Using the USB interface on page 23 for more on this.
10
45
En