Pioneer A-66X Panduan Petunjuk Pengoperasian - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Penguat Pioneer A-66X. Pioneer A-66X 12 halaman.
Halaman Cetak
PANEL
FACILITIES
[MC]
— Released
position;
set to
this position
when
using
|
an MC (moving coil) cartridge
|
[MM]
|
— Depressed
position;
set to this position when
using
an
MM
(moving magnet)
cartridge, or an MC
(moving
coil) cartridge with high output of 1 mV or more.
@
INPUT switches/indicators
[CD]
— Press when listening to a compact disc playback with
a CD player.
[Tuner]
— Press when
listening to AM
or FM broadcasts with
a tuner.
[Phono]
— Press when
listening
to record
playback
on a turn-
table.
[Video 1/AUX 1]
— Press when
listening to programs from
a component
connected to the VIDEO
1/AUX 1 terminals.
[Video 2/AUX 2]
— Press when
listening to programs
from a component
connected to the VIDEO 2/AUX 2 terminals.
[AUX 3]
— Press when
listening to programs
from
a component
connected to the AUX 3 terminals.
VOLUME
control
This control is used for controlling the sound volume.
When set to the [%] position, sound volume is turned off;
when set to the [0] position, sound volume is at a maxi-
mum.
(9) PHONES jack
When using headphones, insert their plug into this jack.
SUBSONIC filter switch
Use this switch when playing records with coarse grooves.
[OFF]
— Released
position;
leave
in this position for normal
playback.
[15Hz]
— Depressed
position;
in this position,
frequencies
of
15Hz
and
below
are cut, thus eliminating
super-low-
frequency
noise caused
by coarse
record grooves, and
thus-helping prevent sound distortion.
() BALANCE control
Should
normally
be left in the center position. Adjust
balance
if the sound
is louder from one of the speakers,
If the right side is louder, turn toward the LEFT position
and
if the left side is louder, turn toward
the RIGHT
position.
d2 LINE STRAIGHT
switch /indicator
By using this switch, the input signals from the various
connected
peripheral
components
can
be
played
back
through
the
amplifier's
modifying
(tone)
circuit,
or
bypassing those circuits.
When
the indicator is lighted, the function is ON.
Input
signals will bypass the modifying circuits and be played
back with pure, flat-balanced tone.
When
set to OFF,
input signals will pass through
the
modifying circuits before being played back, thus allowing
you to adjust bass and treble tone.
(3) LOUDNESS switch
Use when listening at low volume levels.
[OFF] — Released
position:
Should normally be left in
this position.
[ON]
— Depressed position: Boosts low and high frequen-
cies to give added punch to playback even at low volume.
This function does not operate when the LINE STRAIGHT
switch is in the ON position.