Pioneer GM-DX874 Panduan Pemilik - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat Pioneer GM-DX874. Pioneer GM-DX874 16 halaman. Bridgeable four-channel power amplifier
Juga untuk Pioneer GM-DX874: Panduan Servis (17 halaman), Panduan Pemilik (16 halaman)

Halaman Cetak

1. Connecting the Units

Connecting the units

Always use the recommended battery and

ground wire, which is sold separately. Con-

nect the battery wire directly to the car bat-

tery positive (+) terminal and the ground

wire to the car body.

Recommended wires size (AWG: American

Wire Gauge) is as follows. The battery wire,

the ground wire and the optional direct

ground wire must be same size.

Use a wire of 8 AWG to 16 AWG wire for the

speaker wire.

Battery wire and ground wire size

Wire length

less than 4.5 m (14 ft. 9 in.)

less than 7.2 m (23 ft. 7 in.)

less than 11.4 m (37 ft. 5 in.)

Route battery wire from engine com-

partment to the vehicle interior.

When drilling a cable pass-hole into the ve-

hicle body and routing a battery wire thor-

ough it, take care not to short-circuit the

wire damaging it by the cut edges or burrs

of the hole.

After completing all other amplifier connec-

tions, finally connect the battery wire terminal

of the amplifier to the positive + battery term-

inal.

1 Positive + terminal

2 Battery wire (sold separately)

The maximum length of the wire between

the fuse and the positive + terminal of the

battery is 30 cm (12 in.).

3 Fuse (80 A) (sold separately)

Each amplifier must be separately fused at

80 A.

Wire size

8 AWG

6 AWG

4 AWG

Use wire cutters or a utility knife to

strip the end of the battery wire, ground

wire and system remote control wire to ex-

pose about 10 mm (3/8 in.) of the end of

each of the wires, and then twist the ex-

posed ends of the wires.

Connect the wires to the terminal.

Fix the wires securely with the terminal

screws.

1 Battery wire

2 Power terminal

3 Ground wire

4 GND terminal

5 System remote control wire

6 System remote control terminal

7 Terminal screws

Twist

10 mm (3/8 in.)