Pioneer SA-V220 Panduan Petunjuk Pengoperasian - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Penguat Pioneer SA-V220. Pioneer SA-V220 11 halaman. Stereo mixing amplifier

Halaman Cetak

PANEL FACILITIES

REAR PANEL

@ MIC INPUT jacks 1,2 and 3

Connect the MIC cable(s) of the optional video rack. The MIC

INPUT jacks are also used for connection to the optional

wireless mic receiver.

When using microphones with key control remote switch

connected to MIC 1 and 2, connect the control cords to the

KEY CONT jacks.

If a microphone is connected to the MIC jack on the front

panel, front input has priority.

NOTE:

* Position of the key controller may change by connecting/

disconnecting of the remote plug. in such a case, set it again to the

desired position.

¢ For the key control function, both front and rear inputs are effective.

@ VISUAL INPUT jacks

1 LASER DISC

Connect to the VIDEO OUT jack of the LD player.

2 VCR/CAMERA

Connect to the VIDEO OUTPUT jack of the VCR or TV camera.

@ VISUAL OUTPUT jacks

TO MONITOR 1-3

Jacks for connection to the

VIDEO INPUT jacks of TV monitors

(maximum three monitors).

VCR/CAMERA ONLY

Signals input to the "VCR/CAMERA"*

VISUAL INPUT jack of

the SA-V220 will always be output. By connecting to a TV

monitor, you can monitor a VCR or video camera.

@ AUDIO OUTPUT jacks

STEREO

These jacks are used to output the Land R audio signals to the

audio input jacks (LASER DISC, VCR, CABLE, TAPE/AUX) of

this unit. (excluding MASTER

VOLUME

and BALANCE

controls)

MONO

The Land R audio signals input to the audio input jacks (LASER

DISC, VCR, CABLE, TAPE/AUX) always appear as L + R

monaural.

Two speaker systems (A and B) can be connected. For details,

refer to "CONNECTIONS" on page 3.

NOTE:

Always connect the plus (+) and minus (-) wires of the speakers to the

speaker terminals of the same polarity. A polarity error can cause

unnatural sound.

@ VCR VOLUME control

Controls the volume of the VCR input jacks sound.

This control is normally centered but should be adjusted in

accordance with the volume of the LASER DISC.