Pioneer VSA-E03 Panduan Petunjuk Pengoperasian - Halaman 27
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Penguat Pioneer VSA-E03. Pioneer VSA-E03 48 halaman. Audio/video multichannel amplifier
Halaman CetakSwitching ANALOG/DIGITAL Signal Input
The input of the component set in the digital input setting (Refer to page 18) can be switched to an analog or digital
input signal by pressing the SIGNAL SELECT button.
AMP
TV
FQ
+
ENTER
–
FQ
VOL
VOL
CHANNEL
MULTI CONTROL
DVD/LD
TV/SAT
CD
VCR 1
TV CONTROL
TUNER
VCR 2
AMP
MD/TAPE
DSP MODE
MIDNIGHT
1
2
3
4
CH.SELECT
TEST TONE
ATT SIG.SELECT
6
5
7
8
CH.LEVEL
EFFECT
9
0
+10
MEMU
CLASS
TV/VCR
FUNCTION
DIRECT
FL DIMMER
COMMANDER
MODE CHECK
SET UP
Î
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
2
1
Press AMP.
This sets the remote to select the sound mode.
(You can skip this step when using the controls on the amplifier.)
2
Press SIG. SELECT on the remote control or SIGNAL
SELECT on the front panel to select the input signal
corresponding to the source component.
Each press switches between ANALOG and DIGITAL signal selection.
1
SIGNAL
SELECT
ANALOG
2
SIGNAL
SELECT
DIGITAL
3
While SIGNAL SELECT is set to DIGITAL, AC-3 lights when a Dolby
Digital signal is input.
SIGNAL
SELECT
DIGITAL
AC-3
memo
• SIGNAL SELECT is fixed in the "ANALOG" position for components not
assigned to one of the three digital input jacks.
• Because the audio from a karaoke microphone and LD recorded with
analog audio only is not output from the digital output, set SIGNAL
SELECT to "ANALOG".
• This amplifier can only playback Dolby Digital, PCM (32kHz, 44kHz, and
48kHz) signal formats. With digital signal formats other than these, set
SIGNAL SELECT to "ANALOG".
SP
A
SIGNAL
SELECT
ANALOG
A
SIGNAL
SP
SELECT
DIGITAL
SP
A
SIGNAL
SELECT
DIGITAL
AC-3
Sound Modes
When a Dolby Digital signal is input.
27
En