Pioneer PDP-S39 Panduan Petunjuk Pengoperasian - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Sistem Pembicara Pioneer PDP-S39. Pioneer PDP-S39 39 halaman.

Halaman Cetak

English

HOW TO ROUTE CABLES

Bead bands are included with the Plasma Display.

For tidying up your speaker cables, use the bead bands when

needed.

∞ Rear of Display

Speaker Cable

Bead Band

IMPORTANT NOTICE – RECORD THE MODEL NUMBER AND SERIAL NUMBERS OF THIS EQUIPMENT BELOW.

If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in

accordance with legislation that requires proper treatment, recovery and recycling.

Private households in the 25 member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection

facilities or to a retailer (if you purchase a similar new one).

For countries not mentioned above, please contact your local authorities for the correct method of disposal.

By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the

environment and human health.

SYSTEM

CABLE

WHITE

BLACK

Speaker Cable

THE NUMBERS ARE ON THE REAR.

MODEL NO.

SERIAL NO.

KEEP THESE NUMBERS FOR FUTURE USE.

CABINET MAINTENANCE

÷ Use a polishing cloth or dry cloth to wipe off dust and

dirt.

÷ When the cabinet is very dirty, wipe with a soft cloth

moistened with water-diluted cleanser; then wipe again

with a dry cloth. Do not use furniture wax or cleaners.

They may damage the surface of the cabinet.

÷ Never use thinner, benzine, insecticide sprays and other

chemicals on or near the cabinets, since these will corrode

the surfaces.

÷ When a chemical cloth is used, read the cautions for the

chemical cloth carefully.

SPECIFICATIONS

Cabinet: Bass-reflex type

Used speakers (two-way system):

Woofer (for low tones) ................ 4.8 × 13 cm cone type

Tweeter (for high tones) ........... 2.5 cm semidome type

Nominal impedance ..................................................... 8 Ω

Frequency Range ..................................... 70 to 30,000 Hz

Sensitivity (1w, 1m) .................................................. 81 dB

Permissible input :

Max. input .............................................................. 13 W

Rated input .............................................................. 4 W

Crossover frequency ................................................ 3 kHz

External Dimensions ....... 1076 (W) × 83 (H) × 92 (D) mm

Weight ..................................................................... 2.7 kg

Accessory parts (for 2 speakers)

............................................................ Speaker cable × 2

............................................................................. Bracket

........................................................ Screw (M5 × 10) × 9

.............................................. Operating Instructions × 1

NOTE:

Specifications and design subject to possible modification

without notice, due to improvements.

Side × 2

Center × 1

D1-4-2-6-2_En

Published by Pioneer Corporation.