Pioneer S-F52-QL Buku Petunjuk

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Sistem Pembicara Pioneer S-F52-QL. Pioneer S-F52-QL 9 halaman. Pioneer speaker system instruction manual

Halaman Cetak

BEFORE OPERATION

Thank you for buying this PIONEER product.

Read the Instruction Manual carefully before using these speakers so that you

can operate them properly. After you have finished, put this manual away in a

safe place for future reference.

The rated impedance of these speakers is 8 . They must be connected to an

amplifier which accepts this type of load (miminum and maximum impedances

accepted by the amplifier are generally indicated near the speakers outlets: for

example "4

to 16 " or "6

to 16 ").

To guard against damage to these speakers due to an electric power overload,

take the following precautions:

Do not supply more than the maximum permitted power to the speakers

(see Specifications).

Any connection or switching on or off of part of the audio system (CD

player, tuner etc.) must be carried out after switching off the amplifier or at

least with the loudspeaker outlets disconnected (if the amplifier allows).

Interference caused by these operations will otherwise reach the speakers

and may damage the treble loudspeaker units.

When boosting particular frequencies using a graphic equaliser or bass

and treble correctors, make sure that you do not increase the amplifier

volume excessively, as the speakers will be overloaded more quickly.

Do not force a low-power amplifier to produce a high level of sound as

harmonic distortion increases rapidly in this situation and may pose a

danger to the treble speaker units.

Avoid touching the diaphragms and suspensions of speakers units as they are

fragile.

The speaker units in these speakers are magnetically shielded.

However, colours may blur if the speakers are positioned too close to a

television screen. If this happens, switch off the television and switch it

back on again after 15 to 30 minutes. If the problem persists, move the

speakers away from the television set.

INSTALLATION PRECAUTION

For optimum sound reproduction of high frequencies, the treble speaker units

must be at the same height as the listener's ears.

For low frequencies, it is possible to increase the level of bass sounds by

positioning the speakers close to a wall (the maximum increase being obtained

for a position in a corner of the listening room).

Do not install the speakers close to an oven or heating appliance. Avoid

exposing them to direct sunlight. High temperatures can distort the structure of

the enclosure and adversely affect the sound.

These speakers are heavy and fragile, and it is therefore dangerous to install

them in an unstable position.

If the speakers are hung on the wall, for added safety, attach the grilles using

provided accessory parts.

CONNECTIONS

Switch off the amplifier power supply (OFF).

Connect the cables to the input terminals on the rear of the speaker: Connect

the neutral cable to the

terminal and the live cable to the

forget that the red input terminal has positive polarity and that the black input

terminal has negative polarity.

Connect the cables to the loudspeaker outlet terminals of the amplifier. Connect

the live cable to the

terminal and the neutral cable to the

REMARKS :

Check that the cables are securely connected to the terminals. A loose

connection may cause not just intermittent or distorted sound but short-circuiting

and breakdown of the amplifier.

terminal. Do not

terminal.

SPEAKER SYSTEM

ENCEINTES ACOUSTIQUES

LAUTSPRECHERSYSTEM

SISTEMA ALTOPARLANTE

LUIDSPREKERSYSTEEM

HÖGTALARSYSTEM

SISTEMA DE ALTAVOCES

SISTEMA DE ALTIFALANTES

If the cables of one of the speakers have been connected with the wrong

polarities, you will find when listening to a stereo recording that bass sounds are

weakened and the stereo effect normally obtained between the two speakers

does not exist.

MAINTENANCE OF THE ENCLOSURE

Use a cloth to wipe away dust and dirt.

If the enclosure is very dirty, wipe with a soft cloth dipped in a neutral detergent

diluted five to six times with water, then wipe again with the dry cloth. Do not use

thinner, benzene, cleaning sprays or other chemical products on or near the

enclosures as the surfaces could be adversely affected.

SPECIFICATIONS

Enclosure ......................................................................Bookshelf type, enclosed

System ............................................................................. 2 ways, 2 speaker units

Speaker units :

Woofer ........................................................... Cone type, 10 cm

Tweeter ......................................................... Dome type, 2.5 cm

Nominal Impedance ...................................................................................... 8

Frequency range ................................................................... 80 Hz to 20 000 Hz

Sensitivity ..................................................................... 84 dB/W at 1 m distance

Maximum power ........................................................................................ 130 W

Dimensions.......................................130 mm (W) x 203 mm (H) x 153 mm (D)

Weight ..........................................................................................................1.9 kg

Accessory parts

Cables ...................................................................................................................2

Instruction Manual ..................................................................................................1

Warranty ................................................................................................................ 1

Fastener + screws .......................................................................................... 2 + 4

REMARK : The specifications and design of this product are subject to change

without notice, in the interests of improvements.

Discover the benefits of registering your product online at

http://www.pioneer.co.uk (or http://www.pioneer.eu)

http://www.pioneer.co.uk

http://www.pioneer.eu

INSTRUCTION MANUAL

MODE D'EMPLOI

BEDIENUNGSANLEITUNG

GUIDA PER L'USO

GEBRUIKSAANWIJZING

BRUKSANVISNING

GUIA DE OPERACIÓN

GUIA DE OPERAÇÃO

Strip the insulation at the tip of the cord

and twist the strands.

Turn the thumbscrew anti-clockwise,

make sure that the speaker cord is

inserted well into the hole and turn the

thumbscrew clokwise to fasten into

position.

Connect the hot-side speaker cord to the

terminal.

Connect the common-side speaker cord

to the

terminal.

Published by Pioneer Corporation.

2007 Pioneer Corporation.

All reproduction and translation rights reserved.

Printed in China <FRRD-202-B>

English