Pioneer PDP 502MX Manual - Halaman 7

Jelajahi secara online atau unduh pdf Manual untuk Monitor Pioneer PDP 502MX. Pioneer PDP 502MX 11 halaman. Rs-232c control for plasma display monitor, serial commands and protocol
Juga untuk Pioneer PDP 502MX: Brosur & Spesifikasi (8 halaman), Buletin (1 halaman), Buletin (1 halaman), Panduan Petunjuk Pengoperasian (44 halaman)

Halaman Cetak

5.5.5 About the GET commands

What are GET commands?

• These are commands used to transmit adjustment data and other information in TXD to PCs from a microcomputer

inside the plasma display.

• This information s transmitted in ASCII code.

(NOTE) Command names are given I inside < >.

1) <GPS> (GET POSITION DATA) – SCREEN parameters are issued in the following formats.

STX

H.POSITION

(02 hex)

(3 Byte)

(NOTE) • If the present input signal is a video input signal, the adjustment data of CLK FREQ. and CLK PHASE will be

output as dummy data.

• If the present input signal is a PC input signal, the adjustment data of H.SIZE and V.SIZE will be output as

dummy data.

• If the present input signal is "1280 × 1024/60 Hz", the SCREEN adjustment data of present display screen

size will be output.

2) <GWB> (GET W/B DATA) – PICTURE and WHITE BALANCE parameters are issued in the following formats:

STX

CONTRAST

(02 hex)

(3 Byte)

BLUE HIGH

(3 Byte)

COLOR

(3 Byte)...

DUMMY DATA

(3 Byte)

(NOTE) If the present input is PC input, the adjustment data of COLOR, TINT, H. SHARP, and V. SHARP will be

output as dummy data.

V.POSITION

H.SIZE

(3 Byte)

(3 Byte)...

BRIGHT

(3 Byte)

RED LOW

(3 Byte)

TINT

(3 Byte)...

(NOTE)

DUMMY DATA

(3 Byte)

RS-232C Adjustment Mode

V.SIZE

CLK FREQ.

(3 Byte)...

(NOTE)

RED HIGH

GREEN HIGH

(3 Byte)

GREEN LOW

BLUE LOW

(3 Byte)

H. SHARP

V. SHARP

(3 Byte)...

(NOTE)

DUMMY DATA

(3 Byte)

CLK PHASE

(3 Byte)...

(03 hex)

(NOTE)

ETX

(03 hex)

ETX

119