Ariston LI 640 Manual Perbaikan - Halaman 12

Jelajahi secara online atau unduh pdf Manual Perbaikan untuk Mesin pencuci piring Ariston LI 640. Ariston LI 640 33 halaman.

8. SOAP DISPENSER and WATER TEMPERATURE NTC

• To remove the Soap Dispenser (Fig. 8-1), first remove the Actuator Solenoid wiring and then the six (6) Phillips screws that mount

the Dispenser to the Inner Door. The Dispenser can then be removed and replaced as a complete assembly.

OPERATION: The Actuator Solenoid is energized twice during a complete cycle. The first actuation releases the Detergent and

also aligns the Dispenser Linkage for the second actuation which releases the Rinse Agent.

TECH NOTE: Located on the upper right corner of the Dispenser is the Water Temperature NTC. The NTC is hard wired to the

Main Control Board. If the NTC proves faulty the Main Control Board must be replaced. Also, Dishwasher Models

L63 / LL64 / LI 640 / LI 670 incorporate a Magnetic Reed Switch to activate the Rinse Aid LED. Models LL 65 &

LI 700 use a Turbidity Sensor, see Section 19 for details.

• To adjust the tension on the Outer Door turn the two (2) 5mm Allen Screws Clockwise for

more spring tension and Counter Clockwise for less spring tension (Fig. 9-1).

• The Door Latch can be adjusted using a 7mm Nut Driver (Fig. 9-2)

REPAIR MANUAL

L 63 / LL 64 / LL 65

LI 640 / LI 670 / LI 700

Fig. 9-1

Fig. 8-1

Fig. 9-2

Page: 7