Ariston 65 DRY Manual - Halaman 34
Jelajahi secara online atau unduh pdf Manual untuk Pemanas Air Ariston 65 DRY. Ariston 65 DRY 41 halaman.
Halaman CetakBefore you clean the unit, make sure you have turned it off by setting its external switch to OFF. Do not use
insecticides, solvents or aggressive detergents: these can damage the unit's painted and plastic parts.
If the water comes out cold
Disconnect the appliance from the power supply and have the following checked:
- the presence of voltage on the power terminal block (M Fig. 7);
- the circuit board;
- gli elementi riscaldanti della resistenza;
- inspect the bypass pipe (X Fig. 7);
- the sensor holder rods (K Fig. 7)
If the water comes out boiling hot (steam in the taps)
Disconnect the appliance from the electricity supply and have the following checked:
- the circuit board
- the amount of scale on the boiler and components;
- the sensor holder rods (K Fig. 7).
The hot water delivery is insufficient
Disconnect the appliance from the electricity supply and have the following checked:
- the pressure of the water mains;
- the condition of the deflector on the cold water intake pipe;
- the condition of the hot water pipe;
- the electrical components
Water trickling from the pressure safety device
During the healing phase, some water may trickle from the tap. This is normal. To prevent the water trickling, a
suitable expansion vessel must be installed on the flow system. If the trickling continues even after the healing
phase, have the following checked:
- device calibration;
- the pressure of the water mains.
Caution: Never obstruct the appliance outletl
IMPORTANT!
NEVER ATTEMPT TO REPAIR THE APPLIANCE YOURSELF ALWAYS HAVE THIS DONE BY A QUALIFIED TECHNCIAN.
NOTE
The indicated data and specifications are not binding; the manufacturer reserves the right to modify them
at his own discretion notification or replacement.
This product conforms to Directive WEEE 2012/19/EU.
The barred wheeled bin symbol appearing on the appliance or on its packaging indicates that the
product must be collected separately from other waste at the end of its useful life.
The user must therefore deliver the decommissioned product to an appropriate local facility for
separate collection of electrotechnical and electronic waste. Alternatively, the appliance to be scrapped can
be delivered to the dealer when purchasing a new equivalent appliance. Proper separated collection of the
decommissioned appliance for its subsequent recycling, treatment and eco-compatible disposal helps to pre-
vent negative effects on the environment and human health, besides encouraging reuse and/or recycling of
its constituent materials.
34 / EN