Aeotec Door/Window Sensor 6 Panduan Memulai Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Aksesori Aeotec Door/Window Sensor 6. Aeotec Door/Window Sensor 6 6 halaman.

Aeotec Door/Window Sensor 6 Panduan Memulai Cepat

Installation

Whether it?s for security or intelligence purposes, your sensor:
1. Should be affixed indoors and away from sources of moisture.
2. Placed within 30 meters of another Z-Wave device that is either a gateway or not powered by batteries.
3. The magnet and the main sensor must be less than 1.6cm apart for the small magnet installation or 2.5cm apart for the big magnet installation. Main sensor m
be affixed to the door or window and the magnet must be affixed to the frame. The magnet and the main sensor must separate when the door or window is
opened.
4. Should not be mounted on a metal frame.
Affix your Back Mounting Plate and Magnet to a surface.
The Back Mounting Plate can be affixed using screws or double-sided tape and should be mounted on the apex angle of the door. The Magnet must be affixed u
double-sided tape and can?t exceed the valid range, see the figure below.
Note:
1. There are 2 types of Magnets (Magnet 1: 30mm×6mm×2mm, Magnet 2: 30mm×10mm×2mm) , the size of magnet 2 is a little larger than magnet 1, so the
magnetism of magnet 2 is stronger than the magnet 1.
2. You can choose to install each one of magnet on the door frame according to your need or the distance between the door and frame, see the figure below.
3. The Magnets should not be around children to avoid swallowing of the magnets.
When the Back Mounting Plate is affixed by the double-sided tape, wipe the two surfaces clean of any oil or dust with a damp towel. Then when the surface has
completely dried, peel one side of the tape back and attach it to the corresponding section on the rear side of the Back Mounting Plate
http://manual.zwave.eu/backend/make.php?lang=en&sku=AEOEZW112
30-09-2020 13:12
Pagina 2 van 6