Aeotec ZW187 Manual - Halaman 8
Jelajahi secara online atau unduh pdf Manual untuk Aksesori Aeotec ZW187. Aeotec ZW187 11 halaman. Recessed door sensor gen7
Juga untuk Aeotec ZW187: Panduan Pengguna (9 halaman)
Halaman Cetak
3 PRODUCT QUICK START
3.1
Important safety information
Please read this Engineering Specification carefully for correct and effective use.
Failure to follow the recommendations set forth by AEOTEC Limited may be dangerous or cause a violation of the law.
The manufacturer, importer, distributor, and/or reseller will not be held responsible for any loss or damage resulting
from not following any instruction in this guide or in other materials.
Recessed Door Sensor 7 is intended for indoor use in dry locations only. Do not use in damp, moist, and /or wet
locations. Contains small parts; keep away from children.
3.2
Optimally placing the product
Recessed Door Sensor 7 has been designed to be installed within a door and its surrounding frame. To optimally install
it, please note the following.
Recessed Door Sensor 7 must be installed so that its two parts separate when the door it is installed within is opened.
Typically, the larger part is installed in the door itself, while the smaller part is installed in the surrounding frame. This is
not mandatory, however, and the installation can be reversed provided the drill hole instructions are suitably adapted.
As a magnetic sensor utilising wireless communication, Recessed Door Sensor 7 may not optimally work when mounted
on a metal frame or close to metal objects such as door locks. Test accordingly before mounting Recessed Door Sensor
7 with adhesive tape or screws.
To be installed, Recessed Door Sensor 7 requires a minimum spacing of around 1mm / 0.04inch between the door and
its frame when closed. The gap should be no larger than 12mm / 0.47inch.
When the door is closed and the sensor's two parts are installed, they should align.
Owing to both the magnet and the Z-Wave Plus antenna housed with Recessed Door Sensor 7, the two highlighted
areas in this diagram are generally considered optimal.
AEOTEC Engineering Specification
Page 4