Ariston RMC45E-VN Manual - Halaman 6

Jelajahi secara online atau unduh pdf Manual untuk Pemanas Air Ariston RMC45E-VN. Ariston RMC45E-VN 23 halaman. Electric instant water heater

INSTALLATION INSTRUCTION

Caution before

installation!

Install the

appliance

1. Installation must be carried out by qualified personnel and in compliance to

the local authority regulations.

2. This heater must be permanently connected to the direct main current supply.

The use of a plug and socket is not recommended.

3. For the correct size of wire conductor corresponding to different electrical

loading, please refer to table1.

4. This heater operates at a minimum water pressure of 30kPa and 20kPa for

without pump model and with pump model, respectively and at a maximum

water pressure of 380kPa.

5. This heater will not function if there is insufficient water flow to trigger the

flow switch.

6. The built-in ELCB will automatically cut off the power supply in case there

is a current leakage above 15mA. (ELCB model only.)

7. The thermostat will automatically cut off the power supply if it has sensed

an abnormal rise in showering water temperature. Only qualified technicians

are allowed to reset the thermal cut-out built inside the appliance.

8. To avoid accidentally scalding, user is advised to operate the heater under

a water pressure above 30kPa at the inlet.

1. Select a suitable position in the bathroom.

2. Remove the 2 screws at the bottom and 1 screw at the top of the unit(refer to

Fig. 2b), then open the front cover.

3. Mark the screw points of the heater base on the wall. The heater position

should be 1.5 meter from the bathroom floor.

4. Mark the screws points of the slider rail set beside the heater. It is

recommended the top of the portion is in same level with the top of the heater.

5. Use 6mm diameter drill and make the wall plug holes for heater and shower

accessory to 35mm depth.

6. Insert the wall plugs and mount the heater firmly in position with the screws

provided.

7. To mount shower accessory, remove the terminal cover from the mounting

terminal and screw the mounting to position. Close the cover. Insert the shower

holder and soap tray into the slider rail. Mount the slider rail to the mounting

terminal and screw the second mounting to position. Close the cover.