Ariston SB35E-VN Manual - Halaman 6

Jelajahi secara online atau unduh pdf Manual untuk Pemanas Air Ariston SB35E-VN. Ariston SB35E-VN 20 halaman. Electric instant water heater

Water

connection

Testing

connection

Electrical

connection

*THE WATER INLET AND OUTLET MUST BE INSTALLED CORRECTLY;

OTHERWISE THE HEATER CAN NOT FUNCTION.

*DO NOT USE PLUMBING CEMENT ON CONNECTION. IF NECESSAY, USE

ONLY THREAD OR SEALING TAPE.

1. Connect the stop valve to the water inlet with rubber washer. Use correct

tools to tighten and be careful not to break the plastic nut.

2. Insert mesh filter washer then connect the incoming water piping end to the

stop valve (1/2'' BSP).

3. Connect the soft hose and hand shower to the outlet of the heater; be sure

to put in the rubber washer.

4. Hook the hand shower to the shower hanger and adjust to your ideal position.

IMPORTANT: the 'Water Outlet' can only be fitted to the soft hose

and hand shower set provided. NO CONTROL VALVE OR FITTING

CAN BE FITTED TO THE WATER OUTLET.

In the condition of without power supply, turn on the water mains to drain out all

plumbing dirt and to fill up the heater tank. Check for any water leakage.

IMPORTANT: this step will prevent damage to the heating element.

IMPORTANT WARNING

-This appliance must be EARTHED. Improper grounding could cause

electrical shock.

Additional electric switch should be far away from the water heater (out

of reach of shower spray).

-Remember to switch off at mains before carrying out any electrical work.

1. Use double coated flexible cable having nominal cross-sectional area which

could be seen in table 1.

2. lead the power cable from the circuit breaker to "ON/OFF" double bipolar

switch (which having a contact opening at least 3mm in all poles) outside the

bathroom, then lead a cable connected to terminal block inside the unit(fig.3a).

3. Insert the cable through core hitch 'A' for side entry or hole 'B' below the

bottom cover for wall embedded cable (fig.3b).

4.Connect the cable to terminal block and fully tighten them as follow(Fig. 3b).

BROWN or RED for LIVE (L)

BLUE or BLACK for NEUTRAL(N)

GREEN or GREEN/YEOLLOW for EARTH(E)

5. Make sure the wiring connection is tight, then close the front cover.

6. Fix back the screw A.