Ariston ST45PE-VN Manual - Halaman 9

Jelajahi secara online atau unduh pdf Manual untuk Pemanas Air Ariston ST45PE-VN. Ariston ST45PE-VN 26 halaman. Electric instant water heater

Starting

IMPORTANT:

THE HEATER TANK MUST BE FILLED UP WITH WATER BEFORE TURN

ON THE ELECTRICITY SUPPLY THIS IS TO PREVENT ANY DRY BURNT

DAMAGE TO THE HEATING ELEMENT.

SHOULD TURN OFF THE HEATER BEFORE TURN OFF THE STOP VALVE.

OTHERWISE, IT WILL COME OUT A PERIOD OF HOT WATER IFRESTART

THE HEATER IN SHORT TIME, OR CAUSE CONFUSION ON OPERATION

LOGIC DUE TO SPECIAL DESIGN.

1. Turn on the water supply and the stop valve, and then wait until the water flow

through the hand shower.

2. Switch on the electrical supply and the ELCB lamp will light on.

3. Press the ON/OFF button, the heater will begin to work and hot water will come

out in a few seconds. Change the setting temperature by press the "+" or "-" button,

the higher the temperature setting, the hotter is the shower.

4.Press the icon person 1/2/3, it will go to the related setting temperature. This

setting value will be memorized even if power off.

5. The outlet temperature may not be able to reach the setting temperature if

the incoming water supply from the mains is too cold or the flow rate is too high.

In this case, you can reduce the water flow rate which will lead to increase the

outlet temperature, but it is still not necessarily able to reach the setting

temperature in case the water supply really cold.

6. The built-in ELCB will self-check every time when using the product.

7. The height and the direction of the shower holder are adjustable. Depress

the release button and slide the shower holder to the desired position. Move

the hand shower to the desired angle. A ratchet mechanism in the shower holder

will holds the hand shower in the selected position (fig.4).

8.Press the ON/OFF button to turn off the power, then turn off the water valve.

The outlet temperature might be unstable if the inlet water pressure or the voltage

change sharply.

For pump model:

Long press ON/OFF button for 4 seconds, activate/deactivate pump function.