Aeotec Smart Switch 7 Panduan Pengguna - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Beralih Aeotec Smart Switch 7. Aeotec Smart Switch 7 8 halaman.
Juga untuk Aeotec Smart Switch 7: Manual (18 halaman), Manual (6 halaman)
Halaman Cetak
25.11.2019
Single tap
Controls load state.
Press 2 times within
3 second. (Not
Enter pair/inclusion mode.
paired to a Z-Wave
network)
Press 2 times within
1 second. (Paired to
Enters unpair/exclusion mode
a Z-Wave network)
Press 3 times within
Disable alarm response when
2 seconds.
the alarm is activated.
Press and hold for 2
Toggles LED display mode
to 5 seconds.
when SS7 is paired.
Press and hold for 5
Test communication quality
to 10 seconds.
Press and hold for
Reset overload alarm and
10 to 15 seconds.
overcurrent Alarm
Stay in Z-Wave network, but
Press and hold for
factory resets all settings back
15 to 20 seconds.
to default.
Press and hold for
Completely factory reset and
20 seconds and
remove from Z-Wave network.
more.
Important safety information.
Please read this and other device guides carefully. Failure to follow the recommendations set forth by Aeotec Limited may be
dangerous or cause a violation of the law. The manufacturer, importer, distributor, and/or reseller will not be held responsible
for any loss or damage resulting from not following any instructions in this guide or in other materials.
Keep product away from open flames and extreme heat. Avoid direct sunlight or heat exposure.
https://aeotec.freshdesk.com/support/solutions/articles/6000219911-smart-switch-7-user-guide-
Smart Switch 7 user guide : Aeotec Group
LED Follows load control state.
Blue fast blink, after first Click Red
and after second Click Orange.
The LED changes to a green color if
the device paired successfully.
After press 2 times the led indicate
purple.
After inclusion, the LED flashes
Blue
LED flash stops.
Yellow LED
Enabled - LED follows
ON/OFF state.
Disabled - LED is disabled
Indicator Light will become cyan
light when press, and quickly flash
cyan light when release, indicating
start to test communication quality
between the product and Node 1.
At the end of the test, Indicator
Light will display the colour
according to the communication
quality.
Great = green light for 2s.
Good = yellow light for 2s.
Bad = red light for 2s.
Red LED flashes
Red LED Flashes faster.
Fades blue LED in and out slowly
2/8