Aeotec ZW139 Panduan Pengguna - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Beralih Aeotec ZW139. Aeotec ZW139 18 halaman. Nano switch

switch wired into Nano Switch, toggle the button on

the manual switch once and wait 2 seconds for the

Nano Switch to detect the type of manual switch.

You can also set the external switch mode through

Configuration Command Class.

Parameter 120 [1 byte dec] is the parameter that

will set one of the 3 different modes. If you set this

configuration to:

(0) 2-state switch mode

(1) Momentary push button Mode

(2) 3-way switch mode

Touch panel control.

As you can see that the Nano Switch's surface has

a pin port, this port is used to connect the Touch

panel. When you have already connected it to the

Nano Switch, you will be possible to control the

Quick start.

Adding your Nano Switch to a Z-Wave

network.

After your Nano Switch is installed and powered

on, you are now able to manually control the Nano

Switch to turn it On/Off directly via pressing your

Nano Switch's Action Button, it is time to add your

Nano Switch to the Z-Wave network. To set your

Z-Wave gateway/controller into pairing mode, please

refer to the respective section within your controller

instruction manual.

Set your Z-Wave controller into pairing mode.

Press the Action Button on the Nano Switch or

toggle the external manual switch once, the green

LED (non-secure indication) will blink to indicate

the Nano Switch is entering into pairing mode.