Aeotec ZWA003-A/C Panduan Pengoperasian - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Beralih Aeotec ZWA003-A/C. Aeotec ZWA003-A/C 10 halaman.

COMMAND_CLASS_FIRMWARE_UPDATE_MD

COMMAND_CLASS_DEVICE_RESET_LOCALLY

COMMAND_CLASS_CENTRAL_SCENE

COMMAND_CLASS_MARK

COMMAND_CLASS_SWITCH_MULTILEVEL

VI. LOW BATTERY ALARM FUNCTION

NanoMote Quad will send battery report to the lifeline group when button is triggered during

the sleep mode. If the battery level of the NanoMote Quad is less than 20%, the NanoMote

Quad will send a low battery alarm to the main controller.

VII. WAKE UP

Pressing and holding button for 5 seconds and then release so the NanoMote Quad will wake up

itself and send wake-up notification out to Z-Wave Controller. After that, it can be operated to

update parameters, OTA, and detect battery level etc.

VIII. CHILD LOCK FUNCTION

Child Lock function. If enable the Child Lock function, the LED indicator will not be on when press

down the button. To switch on/off the Child Lock function, please press and hold the button for 10

seconds, the LED indicator will be solid on in red. Then release the button, the LED indicator will

be continuously stay in red for 2 seconds. During this 2 seconds, please click the button once, the

LED light will be blink fast in red for 2 seconds.

IX. TESTING Z-WAVE NETWORK RANGE

Press and hold the button for 15 seconds, the LED light will be solid on in purple. Then release the

button, the LED light will be stay in purple for 2 seconds, during this 2 seconds, please click the

button once, it will start to test the Z-Wave network range and LED light will blink fast in purple.

After finish the test, if the LED light is in green, it refers to strong signal; if in blue, it refers to

medium signal, and if in red, it refers to weak signal or no signal.

TIP:

This function works only when NanoMote Quad has been included into a Z-

Wave network.