Aeotec Nano Shutter Manual - Halaman 6
Jelajahi secara online atau unduh pdf Manual untuk Pengontrol Aeotec Nano Shutter. Aeotec Nano Shutter 7 halaman. Z-wave motor controller
Halaman Cetak0x55 (85)
0x78 (120)
0x79 (121)
0xFC (252)
0xFF (255)
Operation Mode 1:
Current state
Stop
Set the operation mode of external switch.
0 = Operation Mode 1.
1 = Operation Mode 2.
For detailed instructions for Operation Mode 1 and 2,
see end of this table.
Set the external switch mode of S1
0 = Unidentified mode.
1 = Reserved.
2 = 3 way switch mode
3 = Push button mode
4 = Enter automatic identification mode (The blue Led
will fast blink).
Note:
When the switch mode of S1 is determined or
identified or configured, this mode value will not be
reset after exclusion.
Set the external switch mode of S2
0 = Unidentified mode.
1 = Reserved
2 = 3 way switch mode
3 = push button mode
4 = enter automatic identification mode (The green Led
will fast blink).
Note:
When the switch mode of S2 is determined or
identified or configured, this mode value will not be
reset after exclusion.
Enable/disable the configuration parameters to be
locked.
0 = disable.
1 = enable.
1, Value = 0x55555555
Reset to factory default settings and removed from the
Z-Wave network
2, Value = 0
D efault = 1
、
Reset all configuration parameters to factory default
settings
Extern button 1
Moving
100%
、
D efault = 1
、
S ize = 4
S ize = 1
、
to
Moving to 0%
Stop
Page 6
0
1
0
1
0
1
0
1
N/A
4
N/A
1
Extern button 2
Moving to
Moving
0%
100%
to