Aeotec WallSwipe Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengontrol Aeotec WallSwipe. Aeotec WallSwipe 5 halaman. For nano

Quick start.

The following will step you through installing WallSwipe, connecting it to Aeotec Nano products, and connecting the Nano

attached to your Z-Wave network.

1. Shut off your home's main circuit breaker of the location that you wish to install Nano + WallSwipe to.

2. Remove and unwire the existing wall switch you wish to replace with WallSwipe. If you have already installed

Aeotec Nano, do not remove it, only remove the wires from the existing wall switch.

Note - You may leave the existing external switch connected if you have additional space to fit WallSwipe and the

external switch. Both WallSwipe and external switch can be used as separate control points for your Nano.

3. If you do not have an Aeotec Nano device already installed, install it by following its respective user guide.

4. (Optional recommendation) It is suggest that you connect the provided JST 1.5mm connection cable to the

WallSwipe before attaching the Nano to the rear of WallSwipe. This will make connecting the cable to Nano easier.

5. Attach the Nano device to the rear of WallSwipe. Secure the Nano device antenna into the Antenna groove.

6. Connect the Nano device to WallSwipe using the provided JST 1.5mm connection cable. Make sure that the cable

is fitted well into Nanos Touch Panel port and inserted the WallSwipe connection port.

7. Use WallSwipe 2 screw holes to affix it to the wall over the installation box.

8. Affix the original or new decora face plate over WallSwipe.

General usecase of WallSwipe.

WallSwipe when attached to Nano will function as a unpair or pairing button and or method to control Nano's functions.

These button functions will work the same across all Nano versions (Dimmer, Switch, Dual Nano Switch).

General button functions.

There are various functions you can do with Wallswipe, this will allow you to unpair, pair, or even factory reset your Nano

without having to remove Nano from your wall.

Button Press

(unpaired) Tap anywhere

once

(unpaired) Tap anywhere

3x times within 1 second

2x Continuous Tap

Function

Pairs Nano with normal pair method (WallSwipe

flashes green)

Pairs Nano with secure (WallSwipe flashes blue)

Send NIF frame (commonly used to unpair

Nano)