Ariston INTESA TP23 Panduan Pengguna, Petunjuk Pemasangan & Servis - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna, Petunjuk Pemasangan & Servis untuk Ketel uap Ariston INTESA TP23. Ariston INTESA TP23 50 halaman.

Halaman Cetak

Winter and Summer Operating Modes

In the 'winter operating mode', the boiler will

produce both Central Heating and Domestic

Hot Water. In the 'summer operating mode', the

boiler will produce only domestic hot water.

Press button "F" to select winter mode. The

green LED "G" will illuminate.

Adjusting the Heating

It is possible to set the temperature of the

heating system by adjusting the knob "B".

By positioning the indicator somewhere

between MIN and MAX, a temperature may

be obtained which varies from approximately

42˚C to about 82˚C.

External (Room) Thermostat Control

If an external (room) thermostat is installed, it is recommended

that the temperature of the heating system be set by means of

the knob "B", leaving it at MAX position in order to obtain the

best performance from the boiler and to allow the regulation of

the external temperature to function efficiently.

Setting the Hot Water for Domestic Use

Both in the winter and summer mode, the temperature of the

domestic hot water may be adjusted by rotating the knob "C". A

delivery temperature for the water may be

selected between approx. 36˚C to 54˚C,

depending on the flow rate of the water and

the position of the knob between MIN and

MAX settings. N

: Should the Domestic

OTE

Hot Water not be hot enough, it may be

necessary to slow the flow rate from the

hot water outlet being used.

Turning Off the Central Heating

To turn off the Central Heating, press the Central

Heating button "F"; the respective green LED "G"

will go off. The boiler will stay in summer mode,

only providing Domestic Hot Water

Turning Off the Boiler

To turn the boiler off, press the button "A"; the

respective green LED "K" will go off.

Supplied By www.heating spares.co Tel. 0161 620 6677

3. Boiler Shutdown Situations

The boiler is equipped with safety devices that intervene in cer-

tain situations and shut it off. Most of these situations are commu-

nicated by means of the LED's and at times the user may be able

to remedy them.

Shutdown Due To Ignition Failure

In the event that the automatic ignition of the

burner has failed, the red LED. "I" will illumi-

nate. In order to reset the ignition, the button

"J" must be pressed and released. Should the

boiler fail to ignite a second time, check that the

external gas cock is open. If the problem per-

sists,

MPORTANT

resetting each time.

Shutdown Due To Overheating

In the event that the safety limit is exceeded for

the temperature of the water in the boilers

exchanger, the thermostat shuts off the boiler

and the red LED "I" illuminates.

To remedy this situation, wait a few minutes to

allow the exchanger to cool down, then press

and release the reset button "J".

If this situation occurs frequently, contact a

local Service Agent.

Temporary Shutdown Due To Defective

Discharge of Exhaust Fumes

The boiler is fitted with safety devices, which in the event of a

defective discharge of exhaust products, automatically interrupts

the gas supply, thereby shutting off the boiler.

The shut-off of the boiler is temporary and is indicated by the illumi-

nation of the yellow L.E.D. "H" for a period of about 15 minutes.

Once this time period has passed and the discharge state of

exhaust system has returned to normal, the boiler automatically

turns back on.

MPORTANT

If this situation occurs frequently, contact a local Service Agent so

that they may check that the exhaust fumes are being expelled

correctly, that the flue is installed correctly and that the area is

ventilated properly.

contact

local

Service

!! Always wait 2 minutes before

Agent.