Ariston A64IMCA1 Panduan Petunjuk Pengoperasian - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Oven Ariston A64IMCA1. Ariston A64IMCA1 20 halaman. Cooker and oven
Halaman Cetak
Installation
! Please keep this instruction booklet in a safe place for
future reference.. Make sure the booklet remains with
the appliance if it is sold, given away or moved.
! Please read this manual carefully: it contains
important information on installation, operation and
safety.
! The appliance must be installed by a qualified
professional in accordance with the instructions
provided.
! Any necessary adjustment or maintenance must be
performed after the cooker has been disconnected
from the electricity supply.
Positioning and levelling
! The appliance may be installed alongside any
cupboards whose height does not exceed that of the
hob surface.
! Make sure that the wall which is in contact with the
back of the appliance is made from a non-flammable,
heat-resistant material (T 90°C).
To install the appliance correctly:
• Place it in the kitchen, the dining room or the studio
flat (not in the bathroom).
• If the top of the hob is higher than the cupboards,
the appliance must be installed at least 600 mm away
from them.
• If the cooker is installed underneath a wall cabinet,
there must be a minimum distance of 420 mm
between this cabinet and the top of the hob.
HOOD
600
Min.
mm.
with the instructions listed in the relevant operating
manual.
This distance should be
increased to 700 mm
if the wall cabinets are
flammable (see figure).
•
Do not position
blinds behind the cooker
or less than 200 mm
away from its sides.
•
Any hoods must be
installed in accordance
Levelling
If it is necessary to level the
appliance, screw the adjustable
feet into the positions provided
on each corner of the base of
the cooker (see figure).
The legs* fit into the slots on the
underside of the base of the
cooker.
Electrical connection
Mounting a Power Supply Cable
Opening the terminal board:
•
Using a screwdriver, prise on the side tabs of
the terminal board cover;
•
Pull open the cover of the terminal board.
To install the cable, proceed as follows:
•
Remove the wire clamp screw and the three
contact screws L-N-
•
Fasten the wires beneath the heads of the
screws using the following color scheme : Blue (N)
Brown (L) Yellow-Green
•
Fasten the supply cable in place with the
clamp and close the cover of the terminal board.
Electrical connection
Ovens with a three-pole power supply cable are desi-
gned to operate with alternated current at the supply
frequency and voltage indicated on the data plate (at
the bottom of the oven dashboard). The earthing con-
ductor of the cable is the yellow-green conductor.
Connecting the power supply cable to the mains.
Fit a normalized plug to the cable, which corresponds
to the load indicated on the data plate; if the cooker is
connected directly to the mains, an omnipolar circuit
GB
N
L
3