Aeotec MULTISENSOR 6 Panduan Pengguna - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sensor Keamanan Aeotec MULTISENSOR 6. Aeotec MULTISENSOR 6 13 halaman. Z-wave water and flood sensor
Juga untuk Aeotec MULTISENSOR 6: Panduan Pengguna (13 halaman), Manual (3 halaman), Panduan Pengguna (8 halaman), Manual (10 halaman)

Aeotec MULTISENSOR 6 Panduan Pengguna
Multisensor 6 user guide : Aeotec Group
Testing Health Connectivity.
Note - Health test does not test for routing communication health, only tests for direct communication with your
gateway to determine if it has a healthy direct connection.
You can determine the health of your MultiSensor 6s connectivity to your gateway using a manual button press, hold,
and release function which is indicated by the LED color.
1. Press and hold MultiSensor 6 Action button
2. Wait until the RGB LED turns into a Purple Color
3. Release MultiSensor 6 Action Button
The RGB LED will blink its Purple color while sending ping messages to your gateway, when it has finished, it will
blink 1 of 3 colors:
Red = Bad Health
Yellow = Moderate Health
Green = Great Health
Be sure to watch for the blink, as it will only blink once very quickly.
Manually Factory Reset MultiSensor 6.
This method is not fully advised unless your gateway has failed, and you do not yet have another gateway to perform
a general unpair on MultiSensor 6.
1. Press and hold MultiSensor 6 Action button
2. Wait until the RGB LED turns from:
- Yellow
- Purple
- Red - blinks faster and faster
- Green - You can let go here, it will continue to the next (Rainbow Cycle)
- Rainbow Cycle
3. If your MultiSensor has been successfully factory reset from its previous network, the RGB LED will be active
with a colourful gradient for 3 seconds. When you press the Action Button on MultiSensor, its green LED will blink.
If the removal was unsuccessful, the green LED will stay solid for a few seconds when you press the Action
Button.
Additional information on other Gateways uses.
https://aeotec.freshdesk.com/support/solutions/articles/6000057073-multisensor-6-user-guide-
29-09-2020 17:00
Pagina 11 van 13