Ariston CX67SP6 X NG Panduan Petunjuk Pengoperasian, Perawatan, dan Pemasangan - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian, Perawatan, dan Pemasangan untuk Oven Ariston CX67SP6 X NG. Ariston CX67SP6 X NG 12 halaman. Cooker & oven
Juga untuk Ariston CX67SP6 X NG: Panduan Petunjuk Pengoperasian (16 halaman), Panduan Petunjuk Pengoperasian (16 halaman)

Ariston CX67SP6 X NG Panduan Petunjuk Pengoperasian, Perawatan, dan Pemasangan
Technical Specifi cations
Gas consumption
Auxiliary Burner
Semi Fish Burner (x3)
Wok Burner
Total
Connections
Gas Inlet fi tting
Location of gas inlet
Electrical input
Location of Electrical Connection
Dimensions
length (side to side)
width (front to back)
height (to cooktop)

Troubleshooting

It may happen that the appliance does not function properly or at all. Before calling the service centre for assistance, check if
anything can be done. First, check to see that there are any interruptions in the gas and electrical supplies, and, in particular,
that the gas valves for the mains are open.
Problem
The burner does not light or the fl ame is not even
around the burner.
The burner does not remain lit when set to minimum.
The fl ame is unusually large, unstable, has excessive
yellow tipping, or appears to lift off the burner ports
The cookware is unstable.
Injector
gas input
diameter
Natural Gas (1.0 kPa)
0.80 mm
3.3 MJ/hr
1.01 mm
5.0 MJ/hr
1.75 mm
15.0 MJ/hr
33.3 MJ/hr
1/2" BSP (male) thread
Bottom rear of upright cooker
95 mm C/L from RH side (as viewed from front)
665 mm from base of upright cooker
Flexible cord and earthed 10 Amp 3 pin plug
Rear of upright cooker
297.5 mm C/L from either side
380 mm from base
595 mm
602 mm
890 mm
Injector
gas input
diameter
Propane (2.75 kPa)
0.50 mm
3.5 MJ/hr
0.64 mm
5.5 MJ/hr
1.05 mm
15.0 MJ/hr
35.0 MJ/hr
Likely cause
The gas holes on the burner are clogged.
The removable parts that make up the burner are mounted incorrectly.
There are draughts near the appliance.
The gas holes are blocked.
There are draughts near the appliance.
The minimum setting has not been adjusted properly.
There is a problem with the burner system which requires immediate
service.
The bottom of the cookware is warped.
The cookware is not positioned correctly at the centre of the burner.
The pan support grids have been positioned incorrectly.
11