Aeotec Z-Stick Gen5 Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Adaptor Aeotec Z-Stick Gen5. Aeotec Z-Stick Gen5 5 halaman. Z-wave usb adapter
Juga untuk Aeotec Z-Stick Gen5: Manual (2 halaman), Manual (11 halaman)

Halaman Cetak

1. While in SerialAPI-mode, Z-Stick is always listening (it is awake and always in RX receive mode) for instructions

and acts as a Z-Wave adapter and responds to commands sent through USB by the host processor software.

2. Pressing the Action Button will not have any effect while in SerialAPI- Mode. But short pressing the Reset Button will

reset the USB port.

Adding Z-Stick to a Pre-existing Z-Wave network.

This must be done through the host software which takes control of Z-Stick USB adapter while Z-Stick is in SerialAPI-

Mode. Please consult the instruction manual of the host software to add the Z-Stick to a pre- existing Z-Wave network

(i.e. "Learn", "Sync", "Add as Secondary Controller", etc.). This function can only be performed via host software.

Reset your Z-Stick.

At some stage, you may wish to reset all of your Z-Stick's settings to their factory defaults. To do this:

Press and hold the RESET Button for 20 seconds and then release it. (You can visually watch the 'C' LED)

The LED will blink red faster and faster over the course of 20 seconds.

The blue LED will solid for 2 seconds as confirmation of a successful factory reset, you may now let go of the

RESET button.

Z-Stick also can be reset to the factory defaults settings via the host software (host software can be any third party

software such as: Homeseer, Domoticz, Indigo, Axial, etc).

The host software must take control of Z-Stick USB adapter while the Z-Stick is in SerialAPI-Mode.

Find the Reset Z-Wave controller option/button/function in your third party software.

Upgrading Z-Stick with the Latest Software.

Note - There is currently no firmware update for the Z-Stick Gen5, but if a firmware update was available, the below

instructions will help you understand how to do so.

1. Download the Aeon Labs Z-Stick upgrade software that contains the firmware update and UART to USB driver.

2. Follow the on-screen instructions to complete installation.

Disable Z-Stick Gen5 LED using Backup Tool

You can disable the LED of the Z-Stick Gen5, there is only one requirement which is the use of a Windows OS to use

Backup Tool.

Please follow the article here and follow through with the step by step instruction set to disable the LED of your Z-Stick

Gen5:

https://aeotec.freshdesk.com/solution/articles/6000171881-how-to-disable-led-on-z-stick-gen5-

(https://aeotec.freshdesk.com/solution/articles/6000171881-how-to-disable-led-on-z-stick-gen5-)