ABB ACS580-01 drives Panduan Instalasi dan Start-Up Cepat - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Instalasi dan Start-Up Cepat untuk Unit Kontrol ABB ACS580-01 drives. ABB ACS580-01 drives 17 halaman. Frequency converter. nec types
Juga untuk ABB ACS580-01 drives: Manual (16 halaman), Panduan Instalasi dan Start-Up Cepat (17 halaman)
Halaman Cetak
- 1. Install the Drive on the Wall
- 2. Remove the Cover(S)
- 3. Connection Procedure
- 4. Connect the Control Cables
- 5. Start up the Drive
- 6. Fieldbus Communication
- 7. Warnings and Faults
- 8. Terminal Data for the Power Cables
- 9. Ambient Conditions
- 10. Safe Torque off (Sto)
- 11. Related Documents
- 12. Declarations of Conformity
Control cable installation examples
This section shows examples for routing the control cables in frames R4 and R6...R9. Frames R1...R3 and R5 are similar to
frame R4.
R4
EIA-485 embedded fieldbus connection
You can connect the drive to a serial communication link with a fieldbus adapter module or the embedded fieldbus
interface. The embedded fieldbus interface supports the Modbus RTU protocol.
To configure Modbus RTU communication with the embedded fieldbus:
1.
Connect the fieldbus cable and the required I/O signals.
2.
If the drive is at the end of the fieldbus, set the termination switch to ON.
3.
Power up the drive and set the required parameters. Refer to
R6...R9
Fieldbus communication
.
10