Ariston EVK4 Series Petunjuk Penggunaan Manual - Halaman 11
Jelajahi secara online atau unduh pdf Petunjuk Penggunaan Manual untuk Kompor Ariston EVK4 Series. Ariston EVK4 Series 16 halaman. Electric built-in cooking hob
Halaman Cetak
Connecting the appliance to the power mains
Important warnings
• The appliance may only be connected by an authorized skilled technician.
• Electric system protection should comply with all relevant regulations.
• The connection clips can be accessed when the connection clip covers are opened / removed.
• Before connecting the appliance, make sure the voltage indicated on the rating plate is
consistent with the voltage in your home circuit.
• The rating plate with basic information is attached on the lower side of the hob.
• The electric circuit should also include an omnipolar switch that will separate the appliance from
the mains, if required, with at least 3 mm of distance between contacts. Suitable devices include
fuses, current protection switches, etc.
• The connection should be selected according to the installation possibilities with regard to
current and fuses.
• Given the protection from the risk of fi re, appliances of this type may be installed in a worktop
next to a piece of kitchen furniture that is taller than the appliance (when installed); however,
in this case, a kitchen furniture element must be installed on the other side, adjacent to the
appliance.
• The current conducting and isolated parts must be protected from any possibility of direct
contact.
Connection diagram
Connection diagram
WARNING!
• Before any intervention, disconnect the appliance from the
power mains. Connect the appliance in compliance with the
electric connections diagram supplied; make sure the relevant
network voltage is observed! The ground wire (PE) should be
connected to the clip indicated by the earthing symbol.
• The mains cable should be fed through the fastening clip
which protects it from being accidentally pulled out.
• After connecting the appliance, turn on all cooking zones /
heaters for approximately three minutes to make sure they are
operating correctly.
• Incorrect connection may destroy parts of the appliance,
making the warranty void.
• Before connecting the appliance, make sure the voltage
indicated on the rating plate is consistent with the voltage
in your home network. Connection voltage (230 V through
N) should be checked by a qualifi ed technician using a
corresponding measuring device!
• Connection cable on the back of the appliance should be led in
such way that it does not touch the appliance back wall, as this
part will get very hot during operation.
11