Ariston NRM 640 X Panduan Petunjuk Pengoperasian - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Kompor Ariston NRM 640 X. Ariston NRM 640 X 16 halaman.
Juga untuk Ariston NRM 640 X: Panduan Petunjuk Pengoperasian (40 halaman)

Halaman Cetak

Ariston NRM 640 X Panduan Petunjuk Pengoperasian

connection required and position the connection

supports as shown in the following table and

diagrams.

4. Position the wires in accordance with the

information given in the following table and diagrams

and connect the appliance by tightening all the

screws for the springs as much as possible.

Voltage and

mains frequency

400V 3-N ~

50/60 Hz

5. Secure the power supply cable by fastening the

cable clamp screw, then put the cover back on.

Phase

Phase Phase

U-bolt

connection support

Electrical connections

Terminal board

Three-phase 400

Neutral Earth

Connecting the electricity supply cable to the

mains

If the appliance is being connected directly to the

electricity mains an omnipolar switch must be

installed with a minimum opening of 3 mm between

contacts.

The installer must ensure that the correct electrical

connection has been made and that it is fully

compliant with safety regulations.

Before connecting the appliance to the power

supply, make sure that:

• The appliance is earthed and the plug is

compliant with the law.

• The socket can withstand the maximum power of

the appliance, which is indicated on the data

plate located on the appliance itself.

• The voltage falls within the range of values

indicated on the data plate.

• The socket is compatible with the plug of the

appliance. If the socket is incompatible with the

plug, ask an authorised technician to replace it.

Do not use extension cords or multiple sockets.

Once the appliance has been installed, the power

supply cable and the electrical socket must be

easily accessible.

The cable must not be bent or compressed.

The cable must be checked regularly and replaced

by authorised technicians only.

The manufacturer declines any liability should

these safety measures not be observed.