Whirlpool 3358968 Petunjuk Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Mesin cuci Whirlpool 3358968. Whirlpool 3358968 5 halaman.

Halaman Cetak
Before you start...
Check
location
where washer will be
installed.
Proper installation
is your
responsibility.
Make sure you have
everything
necessary
for correct
installation.
Grounded
electrical
outlet is
required
See Electrical
requirements.
Standpipe
drain system: Needs a
two-inch
(51 mm) minimum
diameter
standpipe
with minimum
_
Untape
and open washer lid,
Hot and cold water faucets:
Must be
Remove
packages,
hoses and
within 4 feet (122 cm) of the back of the
literature
pack from washer,
-1
washer and provide
water pressure 5-l 00
PSI (34.5-689.6 KPa).
Laundrv tub drain svstem: Needs a 20-
gallon
?76 liter) laundry
tub.
11 11
from bottom
of washer.
Top of tub
must be at least 34 inches (86 cm) high
and no hrgher than 52 Inches (132 cm)
carry-away
capacrty
ot
17 gallons (64 liters)
per minute.
Top of standpipe
must be at least
higher than
72 inches (132 cm)
from bottom
of
washer.
Maximum
height
must
not exceed
52 inches
(132 cm) with 50 Hz
power and 72
from bottom
Floor drain
siphon break,
Part No.
285320
Maximum
height
must not
exceed
52 inches (132 cm)
Water heater:
Set
to deliver
140°F
(60°C) water to
Ad
washer
Important:
Observe
all governing
codes and ordinances.
c a longer &in
ho<& is needed,
drain
hose (Part No. 388423) and hose
extension
kit (Part No. 285442) are
available
from Whirlpool-authorized
parts distributors.
If drain hose must be
shortened,
use kit (Part No. 285442).
Support:
Floor must be sturdy
enough
to support
washer
Tools needed for
Electrical
ifkstallation:
requirements
screwdriver
Parts supplied for
installation:
Remove
parts from packages,
Check
that all parts were included,
weight
of 315 pounds
(143kg).
Level floor:-Maximum
slope under entire
washer -
1 inch (25 cm).
Electrical
Shock Hazard
l
Electrical
ground
is required
on
this appliance.
*If cold water pipe is interrupted
by
plastic,
non-metallic
gaskets or other
insulating
materials,
Do Not use for
grounding.
.Do Not ground
to a gas pipe.
.Do Not modify
the power supply cord
plug. If it does not fit the outlet, have a
proper outlet installed
by a qualified
electrician.
*Do Not have a fuse in the neutral or
grounding
circuit.
A fuse in the neutral
or grounding
circuit could
result in an
electrical
shock.
*Do Not use an extension
cord with this
appliance.
aCheck
with a qualified
electrician
if
you are in doubt as to whether
the
appliance
is properly
grounded.
Failure to follow these instructions
could
result in serious injury or death.
If codes permit and a separate
grounding
wire is used, it is recommended
that a
qualified
electrician
determine
that the
grounding
path is adequate.
A 120-volt, 50/60-Hz, AC-only,
15- or 20-
ampere
fused electrical
supply is required.
(Time-delay
fuse or circuit breaker
is
recommended.)
It is recommended
that
a separate
circuit serving only this
appliance
be provided.
Product Damage
Do Not store or operate
washer
below 32°F (OC) (some water
may remain in washer).
See Use & Care Guide for
"Winterizing"
information.
Failure to follow above
may
result in product
damage.
Recommended
grounding method
For your personal
safety, this appliance
must be grounded.
This appliance
is
equipped
with a power supply cord
having
a 3-prong
grounding
plug. To
minimize
possible shock hazard,
the cord
must be plugged
into a mating
S-prong grounding-type
wall receptacle,
grounded
in accordance
with National
Electrical
Codes, and all local codes and
ordinances.
See Figure 1, If a mating
wall
receptacle
is not available,
it is the
personal
responsibility
and obligation
of
the customer
to have a properly
grounded
3-prong
wall receptacle
installed
by a qualified
electrician.
j-prong
grounding-type
wall receptacle
3-prong
grounding
plug
power
supply cord
Figure 1
literature
package
4 flat water hose washers
1 drain hose
2 front leveling
legs
1 hose clamp
with nuts
2 inlet hoses
1 small clamp
Panel A