Whirlpool 3950318 Panduan Penggunaan & Perawatan - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Penggunaan & Perawatan untuk Mesin cuci Whirlpool 3950318. Whirlpool 3950318 15 halaman. Two speed automatic washers

Halaman Cetak

Washer leaks

Check the following:

Are the fill hoses tight? Are the fill hose washers

properly seated? Is the drain hose clamp properly

installed? See the Installation Instructions.

Is the sink or drain clogged?

Sink and standpipe must be able to handle 17 gallons

(64 L) of water per minute.

Is water deflecting off the tub ring or the load?

Center the tub before starting the washer.

The wash load should be balanced and not overloaded.

The fill or spray rinses can deflect off the load.

The washer must be level. The front feet should be

properly installed and the nuts tightened. Reset the rear

leveling legs (if needed). See the Installation

Instructions.

Check household plumbing for leaks.

Washer basket is crooked

Was the washer basket pulled forward during

loading?

The wash load should be balanced and not overloaded.

Push the basket to the center before starting wash.

Is the load balanced and the washer level?

The wash load should be balanced and not overloaded.

The washer must be level. The front feet should be

properly installed and the nuts tightened. Reset the rear

leveling legs (if needed). See the Installation

Instructions.

The washer basket moves while washing.

This is normal.

Agitator operation

The top of the agitator is loose, or moves in only one

direction.

This is normal.

Dispensers clogged or bleach leaking

Did you follow the manufacturer's directions when

adding detergent and fabric softener to the

dispensers?

Measure detergent and fabric softener. Carefully pour

into the dispensers. Wipe up all spills.

Dilute fabric softener in the fabric softener dispenser.

Did you put powdered or color-safe bleach in the

liquid chlorine bleach dispenser?

Add powdered or liquid color-safe bleach directly to the

basket. Do not use the chlorine bleach dispenser for

color-safe bleach.

Load too wet

Did you use the right cycle for the load being

washed?

Select a cycle with a higher spin speed (if available).

Did you use a cold rinse?

Cold rinses leave loads wetter than warm rinses. This is

normal.

Residue or lint on load

Did you sort properly?

Sort lint givers (towels, chenille) from lint takers

(corduroy, synthetics). Also sort by color.

Did you overload the machine?

The wash load must be balanced and not overloaded.

Lint can be trapped in the load if overloaded. Wash

smaller loads.

Check the following:

Was paper or tissue left in pockets?

Did you use enough detergent? Follow manufacturer's

directions. Use enough detergent to hold the lint in the

water.

Is your water colder than 70°F (21°C)? Wash water

colder than 70°F (21°C) may not completely dissolve the

detergent.

Stains on load

Did you follow the manufacturer's directions when

adding detergent and fabric softener?

Measure detergent and fabric softener. Use enough

detergent to remove soil and hold it in suspension.

Dilute fabric softener and add to rinse portion of cycle

only. Do not drip fabric softener on clothes.

Is there above average iron (rust) in water?

You may need to install an iron filter.

Did you properly sort the load?

Sort dark clothes from whites and lights.

Did you unload the washer promptly?

To avoid dye transfer, unload the washer as soon as it

stops.