Whirlpool 3LCHW9100WQ0 Panduan Petunjuk Instalasi - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Mesin cuci Whirlpool 3LCHW9100WQ0. Whirlpool 3LCHW9100WQ0 48 halaman. Semi-pro front-load washer
Halaman Cetak
3=
Using pliers, tighten the couplings with an additional
two-thirds turn.
4=
Turn on the water taps completely and check for leaks.
NOTE: Replace inlet hoses after 5 years of use to reduce the
risk of hose failure. Record hose installation or replacement
dates on the hoses for future reference.
Periodically inspect and replace hoses if bulges, kinks, cuts,
wear, or leaks are found.
NOTE: Do not overtighten
or use tape or sealants on the tap.
Damage to the inlet hoses can result.
Clear water lines
Run water through both taps and inlet hoses, into a laundry
tub, drainpipe, or bucket, to get rid of particles in the water
lines that might clog the inlet valve screens.
Check the temperature of the water to make sure that the hot
water hose is connected to the hot water tap and that the
cold water hose is connected to the cold water tap.
,,.=I. =._= _II._ I llOSe
Proper routing of the drain hose protects your floor from damage
due to water leakage. Read and follow these instructions.
Remove drain hose from the washer
Gently pull the corrugated
drain hose from the shipping clips.
Connect the inlet hoses to the check valves on washer
(1
H. Hot water inlet
C. Cold water inlet
1. Attach the hot water hose to the check valve on washer's hot
(H) water inlet valve. Screw on coupling by hand until it is
seated on the check valve.
2. Attach the cold water hose to the check valve on washer's
cold (C) water inlet valve. Screw on coupling by hand until it is
seated on the check valve.
3. Using pliers, tighten the couplings with an additional two-
thirds turn.
NOTE: Do not overtighten.
Damage to the coupling can
result.
Laundry tub drain or standpipe drain
Connect the drain hose form to the corrugated drain hose.
A
B
A. Snap either end of the drain hose form to the drain hose
at the point where the corrugation begins.
B. Bend drain hose over drain hose form and snap into place.
To keep drain water from going back into the washer:
•
Do not straighten the drain hose, do not force excess drain
hose into standpipe.
Hose should be secure, but loose
enough to provide a gap for air.
•
Do not lay excess hose on the bottom of the laundry tub.
Floor drain
You may need additional parts. See Floor drain under "Tools
and Parts."
8