Whirlpool 3SWTW4800YQ Manual - Halaman 6
Jelajahi secara online atau unduh pdf Manual untuk Mesin cuci Whirlpool 3SWTW4800YQ. Whirlpool 3SWTW4800YQ 20 halaman.
Juga untuk Whirlpool 3SWTW4800YQ: Panduan Penggunaan dan Perawatan (28 halaman)
Halaman Cetak
7.
Remove drain hose form
(floor drain installations only)
For floor drain installations, you will need to remove the drain
hose form from the end of the drain hose. You may need
additional parts with separate directions. See "Tools and Parts".
Connect Inlet Hoses
Washer must be connected to water faucets with new inlet
hoses with flat washers (provided). Do not use old hoses.
NOTE: Both hoses must be attached and have water flowing
to inlet valves. If you are only connecting to a cold water
faucet, you must use a Y-adapter (provided).
If you have a hot water faucet, go to step 8a.
If you have only a cold water faucet, go to step 8c.
8a.
Connect inlet hoses to water faucets
Attach hose to hot water faucet. Screw on coupling by hand
until it is seated on washer. Use pliers to tighten couplings an
additional two-thirds turn. Repeat this step with second hose
for cold water faucet.
IMPORTANT: Do not overtighten or use tape or sealants on
valve when attaching to faucets or washer. Damage can result.
6
8b.
Connect hose adapter
Coupling
Large flat
washer
NOTE: If the tap does not match the inlet hose connect hose
adapter.
Insert one new large flat washer into one end of each inlet
hose. Firmly seat the washers in the couplings. Screw on
the hose adapter by hand until it is seated on the washer.
Using pliers, tighten the hose adapter with an additional
two-thirds turn.
IMPORTANT: Do not overtighten.
Insert one new small flat washer into the end of the hose
adapter. Firmly seat the washers in the couplings.
8c.
Connect inlet hoses to "Y" connector
Attach the brass female end of the "Y"
connector to the cold water faucet. Use pliers
to tighten couplings an additional two-thirds turn. One end of
the long hose has a wire mesh strainer inside the coupling.
Attach this end to the "Y" connector. Attach washer cold inlet
hose to other side of "Y" connector. Screw on coupling by
hand until it is seated on connector. Using pliers, tighten the
couplings an additional two-thirds turn.
IMPORTANT: Do not overtighten or use tape or sealants
on valve when attaching to faucets or washer. Damage
can result.
9.
Clear water lines
Run water for a few seconds through hoses into a laundry tub,
drainpipe, or bucket to avoid clogs. Water should run until clear.
Make note of which hose is connected to hot water to help in
attaching hoses to washer correctly.
Small
Adapter
flat
washer