Whirlpool 6400 Petunjuk Penggunaan Manual - Halaman 13
Jelajahi secara online atau unduh pdf Petunjuk Penggunaan Manual untuk Mesin cuci Whirlpool 6400. Whirlpool 6400 16 halaman. 6kg, 1400rpm, washing machine with supereco programme, white, wwdc 6400
Halaman Cetak
Description of failure indications
Failure indication
lights up
"Water tap closed"
"Clean pump"
Description - Causes - Solutions
Appliance has no or insufficient water supply. The "Start(Pause)" light flashes.
Check whether:
• Water tap is fully open and water supply pressure is sufficient.
• Kinks are present in water inlet hose.
• Mesh filter of water supply hose is blocked (see "Care and Maintenance").
• Water hose is frozen up.
• Safety valve inspection window of your water supply hose is red (provided
your appliance has a water supply hose as shown on picture "A" - see
previous chapter "Care and Maintenance"); replace the hose by a new one
available through our After-Sales Service or your specialist dealer.
After problem has been removed, restart programme by pressing "Start
(Pause)". If the fault occurs again, contact our After-Sales Service (see next
chapter).
Waste water is not pumped out. The appliance stops in the corresponding
programme step; unplug it and check whether:
• Kinks are present in the drain hose.
• Filter or pump is blocked (see chapter "Cleaning the Filter/ Draining Residual
Water"; make sure the water has cooled before draining the
appliance).
• The drain hose is frozen up.
After problem has been removed, select and start "Drain" programme or push
"Reset" button for at least 3 seconds; afterwards restart desired programme.
If the fault occurs again, contact our After-Sales-Service (see next chapter).
GB 13