Whirlpool 7MWTW1700EM1 Panduan Penggunaan dan Perawatan - Halaman 27
Jelajahi secara online atau unduh pdf Panduan Penggunaan dan Perawatan untuk Mesin cuci Whirlpool 7MWTW1700EM1. Whirlpool 7MWTW1700EM1 32 halaman. Top-loading washer
Halaman Cetak
Troubleshooting
If you experience
Washer not performing as expected (cont�)
Washer won't run
or fill, washer stops
working or wash light
remains on (indicating that
the washer was unable to
fill appropriately) (cont.)
Washer not draining/
spinning, loads are still
wet, or spin light remains
on (indicating that the
washer was unable
to pump out water within
10 minutes)
Dry spots on load
after cycle
First try the solutions suggested here to possibly avoid the cost of a service call.
Possible Causes
Check proper electrical supply.
Normal washer operation.
Washer may be tightly packed.
Small items may have been caught
in pump or between basket and
tub, which can slow draining for
small items.
Use a cycle with a low spin speed.
Washer may be tightly packed or
unbalanced.
Check plumbing for correct drain hose
installation. Drain hose extends into
standpipe farther than 114 mm (4.5").
Too much detergent causing suds to
slow or stop draining and spinning.
High speed spins extract more
moisture than traditional top-load
washers.
Plug power cord into a grounded 3-prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician.
Lid must be closed for washer to run.
Washer will pause during certain phases of cycle.
Do not interrupt cycle.
Remove several items, rearrange load evenly in basket, and add
detergent. Close lid and press INICIO/PAUSA (Start/Pause).
Do not add more than 1 or 2 additional items after cycle has started
to avoid tightly packing or unbalancing.
Empty pockets and use garment bags for small items.
Cycles with lower spin speeds remove less water than cycles with
high spin speeds. Use the recommended cycle/speed spin for
your garment. To remove extra water in the load, select Drenar y
Exprimir (Drain & Spin). Load may need to be rearranged to allow
even distribution of the load in the basket.
Tightly packed or unbalanced loads may not allow the washer
to spin correctly, leaving the load wetter than normal. Evenly
arrange the wet load for balanced spinning. Select the Drenar y
Exprimir (Drain & Spin) cycle to remove excess water. See "Using
Your Washer" for loading recommendations.
Check drain hose for proper installation. Use drain hose form and
securely attach to drainpipe or tub. Do not tape over drain opening.
Lower drain hose if end is higher than 1,22 m (48"). Remove any
clogs from drain hose.
Always measure and follow detergent directions for your load. To
remove extra suds, select Enjuagar y Exprimir (Rinse & Spin). Do not
add detergent.
The high spin speeds combined with airflow during the final spin can
cause items near the top of the load to develop dry spots during the
final spin. This is normal.
Solution
27