Whirlpool 8316473A Panduan Petunjuk Instalasi - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Mesin cuci Whirlpool 8316473A. Whirlpool 8316473A 8 halaman.

Halaman Cetak

WARNING

Electrical Shock Hazard

Electrically earth this appliance.

Do not use an extension cord or an electrical portable

outlet device.

Failure to follow these instructions can result in death,

fire, or electrical shock.

A 240 volt, 50 Hz., AC only, 8 - 10-amp, fused electrical

supply is required. A time-delay fuse or circuit breaker is

recommended. It is recommended that a separate circuit

serving only this appliance be provided.

This washer is equipped with a power supply cord having an

earthing plug.

To minimize possible shock hazard, the cord must be plugged

into a mating, earthing-type outlet, earthed in accordance with

local codes and ordinances. If a mating outlet is not available,

it is the personal responsibility and obligation of the customer

to have the properly earthed outlet installed by a qualified

electrician.

If codes permit and a separate earth wire is used, it is

recommended that a qualified electrician determine that the

earth path is adequate.

Before You Start

WARNING

Excessive Weight Hazard

Use two or more people to move and install washer.

Failure to do so can result in back or other injury.

NOTE: To avoid floor damage, set the washer onto cardboard

before moving across floor.

Remove Shipping Strap

Removing the shipping strap is necessary for proper operation. If

the shipping strap is not removed, the washer will make excessive

noise.

1. Move the washer to within approximately 90 cm (3 ft) of its

final location.

2. The washer must be in the upright position and not tilted

before removing the shipping strap.

Electrical Requirements

INSTALLATION INSTRUCTIONS

Do not earth to a gas pipe.

Check with a qualified electrician if you are not sure the

washer is properly earthed.

Do not have a fuse in the neutral or earth circuit.

EARTHING INSTRUCTIONS

For an earthed, cord-connected washer:

This washer must be earthed. In the event of a malfunction

or breakdown, earthing will reduce the risk of electrical

shock by providing a path of least resistance for electric

current. This washer is equipped with a cord having an

equipment-earthing conductor and an earthing plug. The

plug must be plugged into an appropriate outlet that is

properly installed and earthed in accordance with all local

codes and ordinances.

WARNING:

Improper connection of the equipment-

earthing conductor can result in a risk of electric shock.

Check with a qualified electrician or serviceman if you are in

doubt as to whether the appliance is properly earthed.

Do not modify the plug provided with the appliance – if it will

not fit the outlet, have a proper outlet installed by a qualified

electrician.

For a permanently connected washer:

This washer must be connected to an earthed metal,

permanent wiring system, or an equipment earthing

conductor must be run with the circuit conductors and

connected to the equipment-earthing terminal or lead on the

appliance.

3. Locate the yellow shipping strap on the rear of the machine

near the bottom.

A. Yellow shipping strap