Whirlpool AWG 860 Buku Petunjuk - Halaman 2
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mesin cuci Whirlpool AWG 860. Whirlpool AWG 860 14 halaman.
Halaman Cetak
BEFORE USING THE WASHING MACHINE
1.Removing the packaging and inspection
After unpacking, make sure that the washing
machine is undamaged. If in doubt, do not use
the washing machine. Contact After-Sales
Service or your local retailer.
Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children,
as they are potentially dangerous.
2.Remove the transit bolts
The appliance is fitted with transit bolts to
prevent internal damage during transport.
Before using the washing machine, you must
remove the transit bolts (see Installation/
Remove the transit bolts).
3.Install the washing machine
Move the machine without carrying it by the
worktop.
Install the appliance on a solid and level floor
surface, preferably in a corner of the room.
Make sure that all four feet are stable and resting
on the floor and then check that the appliance is
perfectly level using a spirit level (see
Installation/Adjust the feet).
4.Water supply
Connect the water supply inlet hose in
accordance with the regulations of your local
water company (see Installation/Connect the
water inlet hose).
Water supply:
Tap:
Pressure:
Downloaded From WashingMachine-Manual.com Manuals
Cold water only
3/4 threaded hose
connector.
0.05-1.00 MPa
(0.5-10 bar).
5.Drain
Connect the drain hose to the siphon or hook it
over the edge of a sink with the U bend
(see Installation/Connect the water drain hose).
If the washing machine is connected to a built-in
drainage system, ensure the latter is equipped with
a vent to avoid simultaneous loading and draining
of water (siphoning effect).
6.Electrical connection
Electrical connections must be carried out by a
qualified technician in compliance with the
manufacturers instructions and current standard
safety regulations.
Voltage information, power consumption and
electrical protection data are supplied on the
inside of the filter cover.
The appliance must be connected exclusively by
means of a socket with an earth connection in
accordance with current regulations. The
appliance must be earthed by law. The
manufacturer declines all liability for damage to
persons or property deriving directly or
indirectly from failure to observe the directions.
Do not use extension leads or multi sockets.
Before any maintenance on the washing
machine disconnect it from the mains supply.
After installation, access to the mains plug or
disconnection from the mains supply must be
ensured at all times via a double-pole switch.
Do not operate the washing machine if it has
been damaged during transport. Inform the
After-Sales Service.
Mains cable replacement is only to be carried out
by After-Sales Service.
The appliance must only be used in the
household for the prescribed uses.
Minimum housing dimensions:
Width:
590 mm
Height:
845 mm
Depth:
395 or 335 mm
101