Whirlpool AWO/C 0714 Petunjuk Penggunaan Manual - Halaman 9
Jelajahi secara online atau unduh pdf Petunjuk Penggunaan Manual untuk Mesin cuci Whirlpool AWO/C 0714. Whirlpool AWO/C 0714 14 halaman. 7kg, 1400rpm, 6th sense washing machine with clean +, white wwdc 7410
Juga untuk Whirlpool AWO/C 0714: Bagan Program (2 halaman), Petunjuk Penggunaan Manual (14 halaman)
Halaman Cetak
Description of failure indications
Failure
indication
lights up
"Water tap closed"
"Clean pump"
Appliance has no or insufficient water supply. The "Start(Pause)" light blinks.
Check whether:
• Water tap is fully open and water supply pressure is sufficient.
• Kinks are present in the water inlet hose.
• Mesh filter of water inlet hose is blocked (see "Care and Maintenance".
• The water hose is frozen up.
• The safety valve inspection window of your water inlet hose is red
(provided your appliance has a water supply hose as shown on picture "D" -
see previous chapter "Care And Maintenance"); replace the hose by a new
one available through our After-Sales Service or your specialist dealer.
After problem has been removed, restart programme by pressing "Start(Pause)".
If the fault occurs again, contact our After-Sales Service (see next chapter).
Waste water is not pumped out. The appliance stops in the corresponding
programme step; unplug it and check whether:
• Kinks are present in the drain hose, or the hose is blocked for another reason.
• Filter or pump is blocked (see chapter ("Draining Residual Water/
Cleaning The Filter"); make sure the water has cooled before draining
the appliance).
• The drain hose is frozen up.
After problem has been removed, push the "Reset" button for at least 3 seconds;
afterwards restart the desired programme. If the fault occurs again, contact our
After-Sales-Service (see next chapter).
Description - Causes - Solutions
GB 9