Acom 1200S Panduan Pengoperasian - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Penguat Acom 1200S. Acom 1200S 11 halaman. Hf + 6 m linear amplifier
Halaman Cetak
- 1. Table of Contents
- 2. General Information
- 2. Inroduction and Description
- 2. Owner Assistance
- 2. Equipment Supplied and Options
- 2. Features
- 2. Safety Considerations, Explicit Definitions
- 3. Installation
- 3. Unpacking and Initial Inspection
- 3. Amplifier Operating Location Selection; Cooling
- 3. Connecting the Amplifier Within the Shack
- 3. Installing Options and Connecting to External Devices, Computer, Etc
- 4. Powering and Operation
- 4. Low Energy Standby Mode of the Power Supply
- 4. Front Panel - Controls and Indication
- 5. Specifications
1. GENERAL INFORMATION
Inroduction and description
1-1.
This manual describes the installation, operation, and maintenance of the HF+6m solid-state linear
power amplifier ACOM 700S.
ACOM 700S is a state-of-the art linear amplifier, covering the amateur bands from 1.8 to 54MHz with
700W output power (PEP or continuous carrier) with less than 40W of drive. The amplifier operating
information is shown on a multi-functional, high resolution color display. ACOM 700S may by controlled
either by the six front panel buttons or remotely – via an RS232 port.
Owner assistance
1-2.
If technical or operating assistance is needed, please contact your local dealer first. In the unlikely
case of you needing further information, you may get in touch with ACOM via: fax (+ 359 2 920 96 56),
telephone (+359 2 9209780), e-mail ([email protected], [email protected]) or by post (blvd.
Nikola Mushanov 151, 1330 Sofia, Bulgaria). Website: www.acom-bg.com.
Equipment supplied and options
1-3.
The amplifier is supplied in a single box including:
-
amplifier ACOM 700S;
-
power cord;
-
this manual with a CE declaration of compliance;
-
four pieces of spare fuses
Features
1-4.
•
5" high resolution color display (108x65mm), 800x480 pixels, and 24-bit color.
•
The final PA stage uses a rugged LDMOS transistor - BLF188XR.
•
Compatible with all transceiver models available on the market - does not need any special
signals: „ground on transmit" and less than 40W of RF drive power is sufficient.
•
Broadband input circuit, providing a perfect transceiver load with SWR below 1.2:1 (typically
1.1:1), without retuning throughout the whole frequency range from 1.8 to 54MHz.
•
The overall operation of ACOM 700S is extremely simplified : the screen menus are intuitive
and easy to follow, no special skill is required from the operator when changing frequency
bands.
ACOM 700S
is designed to work with the ACOM 04AT Remote
Automatic Antenna Tuner. The connection of ACOM04AT will make
accessible the features that are inactive onthe amplifier display when
ACOM 700S operates without
ACOM 04AT. The operation of ACOM 700S with ACOM 04AT
is described in the ACOM 04AT Operation Manual.
NOTE
3