Whirlpool CA2762XYW0 Panduan Petunjuk Instalasi - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Mesin cuci Whirlpool CA2762XYW0. Whirlpool CA2762XYW0 8 halaman. Commercial electronic washer 120 volt 60hz models
Halaman Cetak
Use
new hoses and washers that
came with your Whirlpool washer.
coupling
washer
= Insert a flatwasher
into each
end of the inlet hoses. Check that
washers are firmly seated
in
couplings.
Inlets are plastic.
Do Not strip or
crossthread.
== Place hose clamp
over washer
drain connector.
Push drain hose onto
washer connector,
use pliers to open
clamp
and slide clamp
over drain
hose, Check for good fit,
g==
Stack two corner posts on top of
each
other. Tilt washer backwards
and insert corner posts 3 inches in
from one side of washer as shown.
Repeat
with other corner posts on
other side of washer,
I/2"
base
hose to bottom
inlet
valve opening
first. Then second
hose
to top inlet. Tighten couplings
by
hand; then use pliers to make an
additional
two-thirds
turn.
Slide washer onto cardboard
or
hardboard
before
moving
across
floor,
== Measure
and mark a point
approximately
] 6 inches from the
plug end of the shipping
strap. Cut
this shipping
strap at this point.
Check that hose is not
twisted or kinked and
is securely in place.
Put "hook"
end of
drain hose into
standpipe.
Tightly
wrap the shipping
strap around
the
standpipe.
Push plug
into the nearest hole
in the shipping
strap,
== Move washer close to final
position.
Put "hook"
end of drain hose
into standpipe.
Estimate length of
drain hose needed
when washer
is in
final position. Hose must be cut
exactly
to length so "hook"
end is
held tightly over edge
of standpipe.
If
drain hose is too long, cut straight
end
of hose, (Do Not cut "hook"
shaped
end of drain hose.)
DO NOT FORCE EXCESS LENGTH OF
DRAIN HOSE DOWN THE STANDPIPE.
THISCOULD CAUSE SIPHONING. See
Step 6.
PAGE4
I
== Before attaching
water
inlet
hoses, run water
through
both faucets
into a bucket,
This will get rid of
particles
in water
lines that might clog
hoses. Mark which
is the hot water
faucet,
bottom
hose (inlet
marked
"H') to hot water
faucet.
Attach
top hose (inlet marked
"C') to
cold water
faucet.
Tighten coupling
to faucet
by hand; then use pliers to
make final two-thirds
turn.
nut
0
==Use legs and nuts from parts
package.
Screw nut down to within
]/2 inch of base,
11.
Insert legs into
correct
holes at
front corner of washer
until nuts touch
washer. Do Not
tighten
nuts until Step 14,
2
==Tiltwasher backward
and
remove
corner posts. Gently
lower
washer to floor,
Move washer to its permanent
location. Remove cardboard
or
hardboard
from under washer.
JA
13
==Tilt washer forward
raising
back legs 1 inch off of floor. To adjust
rear self-leveling
legs, gently
lower
washer to floor, Check
levelness of
the washer by placing
a carpenter's
level on top of the washer, first side to
side; then front to back,