AEP Span Select Seam Panduan Petunjuk Pengoperasian - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Sander AEP Span Select Seam. AEP Span Select Seam 6 halaman. Narrow batten architectural metal roofing curving machine
Halaman CetakBATTEN CAP CURVING
1. Set both the entrance rolls to the bottom set of scribe lines for the batten cap. Check
to see the direction that the cap curving rolls are facing. Lay the cap on the side that
matches the form of the curving rolls, and feed into the machine. Note: The jeweler
saw blade should be on the inside of the batten caps.
2. The batten cap curving setting will be a different setting than was used to produce the
matching panel. It is an opposite adjustment with the curving rails than with the Select
Seam panel. Remember to note your settings on the caps based on the type of material
and thickness.
3. The cap must also be supported as it
exits the machine.
SSM Curving Machine Operating Inst.
Page 5 of 6
Rev.12/14/11