Whirlpool WASHER Panduan Petunjuk Instalasi - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Mesin cuci Whirlpool WASHER. Whirlpool WASHER 8 halaman. Washing machine
Juga untuk Whirlpool WASHER: Panduan Petunjuk Instalasi (16 halaman), Panduan Petunjuk Instalasi (27 halaman), Petunjuk Pengguna (8 halaman), Petunjuk Pengguna (20 halaman), Petunjuk Pengguna (24 halaman), Petunjuk Pengguna (8 halaman), Panduan Petunjuk Instalasi (20 halaman), Petunjuk Pengguna (15 halaman), Panduan Penggunaan & Perawatan (40 halaman), Panduan Petunjuk Instalasi (16 halaman), Petunjuk Pengguna (8 halaman), Bagan Program (2 halaman), Petunjuk Instalasi (5 halaman)

Halaman Cetak

Whirlpool WASHER Panduan Petunjuk Instalasi

Steps in Final Location

1. Slide the washer to its final location.

2. Tilt the washer forward until the rear of the washer is at least

10.2 cm (4") off the floor. You may hear the self-adjusting rear

feet click into place. Lower the washer to the floor.

A. Self-adjusting feet

3. Check the levelness of the washer by placing a level on the

top edges of the washer, first side to side, then front to back.

4. If the washer is not level, move the washer out slightly, tip

back, prop up the front of the washer with the wood block and

adjust the feet up or down as necessary by twisting the feet.

Turn the feet clockwise to raise the washer or

counterclockwise to lower the washer. Repeat steps

1 through 4 until washer is level.

5. After the washer is in its final location and level, use a 14 mm

or ⁹⁄₁₆" open-end wrench to turn the nuts counterclockwise on

the feet tightly against the washer cabinet.

IMPORTANT: If the nuts are not tight against the washer

cabinet, the washer may vibrate.

8316471

10.2 cm

(4")

Benton Harbor, Michigan 49022

Complete Installation

1. Check the electrical requirements. Be sure that you have the

correct electrical supply and the recommended earthing

method. See "Electrical Requirements."

2. Check that parts are now installed. If there is an extra part, go

back through the steps to see which step was skipped.

3. Check that you have all of your tools.

4. Check that the yellow shipping strap was completely removed

from the lower back of the washer.

5. Dispose of or recycle all packaging materials.

6. Check to be sure the water faucets are on.

7. Check for leaks around faucets and inlet hoses.

WARNING

Electrical Shock Hazard

Electrically earth this appliance.

Do not use an extension cord or an electrical portable

outlet device.

Failure to follow these instructions can result in death,

fire, or electrical shock.

8. Plug into an earthed outlet.

9. Remove the protective film on the console and any tape

remaining on the washer.

10. Read "Washer Use" in the Washer User Instructions.

11. To test and to clean your washer, measure ¹ ₂ of the normal

recommended amount of powdered or liquid detergent and

pour it into the washer basket or detergent dispenser (on

some models). Close the lid. Select any cycle, and then pull

the cycle control knob out to start the washer. Allow it to

complete one whole cycle.

4/05

Printed in U.S.A.

Impreso en EE.UU.

Imprimé aux É.-U.